Basher Nitro Circus MT - Rear Suspension Arms
Hmotnost ( g )
Used as hopup for Sabertooth. All connections are the same, except arm pins that are 6 instead of 4mm, and no droop screw holes (because of different arm design it's not even possible to drill them by yourself). You also have to use Nitro Circuis pins, pin holders & bumpers to mount them, since stock sabertooth ones, even if you increase the pin holes don't have enough clearance. Much stronger / less flex that the sabartooth ones and of course no more problems with broken pins & bent dogbones/cvd's!On geometry coincide with levers for SaberTootn.
But thicker 1mm = 11.7 vs. 10.7.
And hole for the axis is of 5 mm vs. 4 mm SaberTootn.
With minor alterations or replacement axle mounts from Circus MT are suitable for installation on SaberTootn - this will be enhanced version :)