A perfect brushless system for any 1/8 scale car, truck, or buggy.The specially designed motor gives more run time and comes with thermal protection.Brushless Electronic Speed Controller(ESC).
Execellent throttle response, acceleration, strong brakes and throttle linearity
Programable with a B6090 programming card to make adjustments.
Automatically detects the number of cells within the battery pack.
Multiple protection features: Low voltage cut-off protection, over-heat protection, throttle signal loss protection.
Reverse power (Off, Low, Medium, Hi)
Start power (Standard, Low, Medium, Hi)
Drag (Neutral) Brake (Off, Low, Medium, Hi)
Battery type (Ni-mh, Ni-cd, Li-xx)
Default, Manual settings
Continuous Current: 80A
Burst Current: 150A 640W/30sec
Resistance: 0.016 ohm
Suitable Car: 1/10 on and off road.
Battery: 7.4~14.8V 2~4cell Lipo / NI-xx
Bec output: 5V/2A
Dimension: 50 x 45 x 27mm
Motor: 540L 1700kv
Type: Sensorless brushless motor
Max operating current: 40A
Max operating speed: 14.8/25610rpm
Max efficiency 80%bmax.
Shaft length: 16.3mm
Shaft size: 5mm
ESC: 1 x 80A
Motor: 1 x B221X17 (1700Kv)
Kapacita ( mAh )
Hmotnost ( g )
Good setup, bullets didn't match the esc connectors, had to resolder the esc side.
easy to setup and very powerfull. broke 1 blade of the fan, no further issues.
3 stars because 1 blade of fan broke quick without any crash and because the connectors didn't fit.recebi este combo hoje e esta muito bom para o preco..Mounted this today on my son's E-maxx. Motor fits fine, used dual side sticky foam to fasten the ESC. But Hobbyking, what's up with the connectors?! They dont match! Had to change the ESC side, luckily I hade some spares from my helicopter.
Performance seems OK, have only tested it with a pair of old 3000mAh NiMh sofar, and a 21T pinion. Power is like standard motors when it was new. I expect it to be faster with Lipo.
The finish is excellent!Got this today. Everything looks good. On ly problem so far is the bullets on the motor are a different size as the esc, This doesn't make sense. I am going to have to solder them directly for it to work.