Weight: 14g (with 10cm wire)
Idle Current: .2A
Max amp: 10A (15sec burst)
Voltage: 2-4cell Lipoly
We do not have a suggested prop size for this little motor yet.
Once we have the data, we will include it within this listing.
Hmotnost ( g )
Kv (rpm / v)
Maximální proudy (A)
Výkon ( W ):
Délka B ( mm ):
Může Délka D ( mm )
Maximální napětí ( V)
Hřídel A ( mm ):
Unit Weight (g):
Průměr C ( mm )
Celková délka E ( mm )
Odpor ( mh):
Great little motor, love the power and reliability I will buy more of these for sureI don't think you could find a worse design for a RC motor. You can not attach a propeller any way to it. You have to use the "integrated" prop saver design. Integrated and unremovable. I installed the propeller with the provided O rings, and they just came off at half throttle, or the ring snapped. No matter what you do, they are not good. You don't have to trust me, spend your money on these motors, and convince yourself.
Now i have four motors to use for.....uh....uh.....Perfect fit for Mini Swift. Flies on both 2S and 3S using a 5043 prop. On 2S, it flies like stock. On 3S, it does great power verticals and out-of-control prop rolls. This should be the stock setup for that plane. It can probably handle other prop combinations too.This is a fantastic little motor! I purchased it to use on my Mini Skywalker, and when used with a 3S and 5x3 prop that plane is a rocket! I'm not using it for FPV flight so mine is lighter than normal, but since this motor is rated to 4S it's likely to just rip the wings off that plane if (when?) I try it.Ser que presta?? espero que sim!I don't think you would want to run one of these motors to 10 amps. Mine cuts out before reaching 3 amps with a 6x5 prop and even then it is getting warm.fragilit des fils, a coller avnt toute manipulationParfait pour quiper une mini swift
avec controleur Turnigy 6A un hlice 5x3 et accus 2S 500mAh
poids en ordre de vol 108 g. vol lent en indoor et se dfend en extrieur mme avec un vent moyen
seuls les lastics sont difficiles trouver
excellent petit moteur50/50 chance of working. Prop saver idea works well on this size motor although have concerns about availability of replacement rubber rings over the life of the motor.Little motor but gives very nice perfomance, I used in my foamy which weights 150 grams with GWS 5030, Rhino 360, ESC 6A Turnigy plush...
It can also do loop so VERY HAPPY WITH THIS MOTOR...