CNC Alloy Throttle Arm for Gas Engines - 2mm threaded hole for pushrod ball-link/clevis.
Hmotnost ( g )
Muy util y barato....I have used several of these on Walbro carbs to solve a common problem involving clearance and positioning of the throttle arm on my gas powered planes. Perfect fit with extended housing and arm make life hooking up the throttle much easier. I recommend them.Perfect. These arms work great with almost ANY Walboro carbed engine.
Remove the existing screw, pry off the old short arm, and insert this one. Tighten down the berg screw and you're done.
You can install a ball socket screw for a freely moving throttle linkage setup.
Very impressed with arm, appears chrome plated, very attractive. Fits on my RCG26 and DLE30 easily. Specs are as follows: ID is abt 4.8mm as fits throttle shaft of 4.75mm snugly, OD is 9.5mm/.375", overall HT is 18.5mm/.731", Center shaft to 2mm linkage hole is 17.35mm/.731", overall width is 25.1mm/.99". Uses a 3mX3m set screw requiring a 1.5mm hex driver. These measurements are as accurate as I could obtain using electronic caliper. I will order additional arms for other engines. Hope this helps those needing dimensions. Would work on chokes with same diameter shafts.Very good arm for gas engines.Excellent solution to an often overlooked problem. Fits, works and alieviates problems with the choke rod fouling the throttle rodfiyatna gre ok kaliteli bir rn...