A lot of servos of different volume and weight come out in todays model market. Though they have higher rotational speeds and torque, they dont have the characteristics of digital servos.
• Higher resolution
• The tightest dead band
• Accurate positioning
• Faster control response
• Quicker acceleration
• Constant torque throughout the servos travel
• Increased holding power when stationary
Operating voltage range: 4.8V~6.0V
Operating temperature range -20° to +60°
Operating speed: 0.12sec/60°
Stall torque: 1.8kg.cm
Standing torque: 1.8kg.cm hold out @ 5°
Running current: 200mA/60° no load
Dead band width: ¡Ü3usec
Operating travel: 40°/one side pulse traveling 400usec
Motor type: Cored metal brush
Potentiometer type: 2 slider/direct drive
Ball bearing: MR85
Gear material: Heavy duty resin
Connector wire length: 215mm(8.46in)
Spline count: 21
See the DS-928B User Guide for more details.
Hmotnost ( g )
Rychlost ( Sec / 60deg )
Točivý moment ( kg) (min . 0,01 kg )
Unit Weight (g):
A ( mm ):
B ( mm )
C ( mm )
D ( mm ):
E ( mm ):
F ( mm )
Good for Bravado. Should be better in metal version. Doesn't like shocks but you shouldn't do that. Come back very properly, neutral position always achieved.Nice high torque, not the fastest servo ever and they seem to do okay centering, but the whine at center is pretty bad. I put 4 of these in the MX2 955mm EPO and sitting there with no input at all sounds almost like a chorus of dentist drills in the distance. I haven't measured the voltage draw at center, but that much noise makes me concerned. Maiden flight went well, the sound was my only complaint. Speed at .12 seconds is okay. I may upgrade to something faster as I get more proficient in 3D. Would recommend as a mid-level budget torque servo.the servo arm rattles already on the shaft. Can not be used in a model airplane .
I thought Hobby King is testing the products they offer here .
I'm disappointedHola amigos tengo 3 servos de estos en el plato ciclico y funcionan muy bien ya tienen un ao y no me han dado ningun problema buenos servos por buen precio.Replaced cheap aileron wing micro servo's from Topflite in my STARMAX MX2 with Corona DS928BB digital servos. What a pleasure - smooth movement lovely to fly recommendedterimakasih telah menghubungi hobbygabus di tunggu transaksinya
contact / 0821-3719-3719 pin 21b9f939Just recieved these servo's to put them in a parkflyer Yak.. 1 servo was broken when i tested it to his maximum travel range.. These servo's are in my opinion ok for a foamy indoor plane, but for parkflyers i would chose the one with metal gear.Just brought 4 of them for my axn couldn't understand that 2 didn't work untill I removed the case to find no solder on a connection poor!The servos wine constantly under any strain at all. My plane sounds like it is playing music! Save your money!Bon servo prcis.
Excellent rapport qualit prix