Diatone V8.3 LC Filtered PDB Power Hub with 5V and 12V BEC
The Diatone V8.3 LC Filtered PDB Power Hub comes with some great features such as the ability to solder the ESCs onto either side of the PCB. The ESC solder pads have been redesigned from previous boards to make it easier solder on both X and H frames.
The 36x36mm size makes it easy to stack with the flight controller. 2 sets of BEC circuity provides 5V and 12V for using servos, video transmitters, LEDs, etc. Another new feature on the V8.3 board is the addition of an ESC signal channel for easy soldering and neat, compact wiring. The PDB supports 3~6S (11.1V~22.2V).
The new LC filter circuit uses a superior filter inductor and 47uf tantalum capacitor. With a 1A electrical load the 5V ripple is only just 31mV, the 12V ripple is only just 63mV. The camera and video transmitter now have a filtered power source.
Look no further this is a PDB that needs to be in your order.
• ESC can be soldered onto either side of PCB (tabs on both sides)
• 2oz copper and 4-layers PCB
• Low Ripple current
• ESC and Battery solder tabs in pairs
• Solder Bridges of 5V and 12V for Camera and VTX power
• DC/DC synchronous buck regulator, efficiency is up to 95%
• 5V and 12V Output LED indicators and short circuit tolerance
Working Voltage: 3~6S LiPoly (11.1-22.2V)
Output Voltage: 5V and 12V
Output Current: 2A
ESC outputs: 4
Current output: 4 x 20A
Size: 36 x 36mm
Mounting: 30.5mm / Φ3mm
1 x Diatone V8.3 PDB
1 x Cable
Hmotnost ( g )
Nice PDB,great LC-FIlter and connection to FC...PDB di qualità, oltre a ridurre il numero di cavi e rendere il vostro quad 250 più ordinato, offre la possibilità di prelevare le tensioni 5V e 12V (corrente stabilizzata e filtrata) per alimentare videocamera, ricevente, e luci LED senza l'ausilio di ESC con BEC interno, ridecendo in questo modo il consumo di corrente totale.The best thing about this PDB is not the LC filter (that is good also), but the ESC servo connector to the FC. Direct solder your ESC signal wire to the PDB and then solder the channel signal wire to the FC. For those of us who are neatness freaks......this is perfect!