Registrovat

Product Finder

Nastavení

Useful links

Live Chat
 
[["US","AU","GB","DE"]]
Registrovat

Flycolor 30 Amp Multi-rotor ESC 2~6S Opto

Flycolor 30 Amp Multi-rotor ESC 2~6S Opto

Discontinued Product

Please continue searching for a similar product.
Stock:
OUT OF STOCK
Váha:
31 g
SKU:
261000024-0

Combine

essential items and
acc
Popis
produktu

These Flycolor electronic speed controllers have been developed specifically for multi-rotor use. They use a high performance MCU processor that gives a smooth linear response which is perfect for multi-rotors.

The Flycolor electronic speed controllers feature over thermal protection, will shut down if signal is lost, have low voltage protection, abnormal input voltage protection and much much more.

Features:
• Developed specifically for multi-rotor use
• Smooth, linear throttle response
• Uses powerful, high performance MCU
• Supports constant speed
• Multiple self protection functions: abnormal voltage input, low battery protection, over thermal protection, throttle signal loss
• Safe start, motor will not run until ESC is armed correctly
• Programmable via throttle stick (see instructions under "Files" tab)

Specs:
Constant Current: 30A
Max Burst Current: 40A
Input Voltage: 7.4V~22.2V (25.5V max)
BEC: None
Dimensions: 50x23x9mm
Weight: 24g
Servo Lead: JR Type

Please note: This is an Opto speed controller so requires a separate power source for the receiver also no battery or motor connectors are supplied.

Product
Specifications

Další informace

  • SKU:
    261000024-0
  • Brand:
    Ne
  • Kapacita ( mAh )
    Ne
  • Hmotnost ( g )
    31.00
  • Délka:
    100.00
  • Width:
    10.00
  • Výška
    85.00
Community
Discussions
Rate&
Review

Napište vlastní recenzi

Only registered users can write reviews. Please, sign in or sign up

verified_user Quality
trending_up Value
playlist_add_check Overall
Using these on a quad-copter using Quanum MT Series 3510 360KV motors on 6s. the setup i have could be a bit big for these but they are performing very well so far after 5 flights. I did install small vga heat sinks on them as i was a bit worry about the heat but that is now solved, placed them in the prop wash, running cool now.. the esc seem responsive, no need to flash them..
verified_user Quality
trending_up Value
playlist_add_check Overall
verified_user Quality
trending_up Value
playlist_add_check Overall
Purchased three of these for a HV 6S tricopter. They are tiny compared to other lower voltage ESC's. Soldering quality is excellent and they do the job. They get warm very quickly on 6S. I am not sure if i want to run 6S for to long on these sec's. Have been using 3S most of the time. They are very smooth to fly, and perform well for my application. Found that the heat sink will fall off the chip sets when you remove the head shrink, make sure to put it back on before sealing them up again after soldering motor and power wires to them. So far so good. Have not changed any settings just yet so can not comment on the correctness of the manual in the files tab. Just soldered them in and went flying. Good no fuss SC.
verified_user Quality
trending_up Value
playlist_add_check Overall
Upload
Videos
Upload video
Upload
Files

Only registered users can upload files. Please log in or register to start helping your fellow hobbyists today!

Customer files
Flycolor Manual download now [505kb]

Combine

essential items and
acc

Štítky produktu

Štítky oddělujte mezerou. Víceslovné uzavřete v apostrofech (').