The FrSky Lipo Voltage Sensor features a colorful, easy to read OLED display screen. It can be used as a stand-alone unit for checking the voltage of your lipoly cells, or can be used in conjunction with the FrSky DHT-U telemetry display system as an add-on sensor to monitor your battery.
The sensor cable (for use with DHT-U) is included.
Measurement range: 1~6S lipoly
Cell voltage display range: 0.20~4.20V
Voltage display resolution: 0.01V
Voltage detection precision: 0.05V
Current of the board: 15.5mA
Operating temperature range: -30°C~70°C
Pixel: 128x64 with OLED display screen
Hmotnost ( g )
works great and very handy. a great addition to my taranisProduct defective, dont work, arrive now and trash.... Dont buy this...
Produto com defeito nao funciona, lixo! Nao compre...CHECK THE DISCUSSIONS BEFORE YOU PURCHASE.
It lasted me all of a couple minutes. Now it only shows a 2s no matter if I connect a 3s or 4s.
I'd wait till they get this thing debugged. There has been quite a few failures. Mine included.
When it worked it was cool. The output worked great for my telemetry and was able to read it on my transmitter. I would have given it 5 crowns.accurate and light ,all goodCute tiny sweet sensor with super nice OLED display, bright and perfectly readable even on bright sun, wok even standalone, wonderful. Definitely my favorite FrSky telemetry sensor!
This I would said last week, until it started to show too low error voltages on two cells (2 & 3) and finally cell 3 disappeared definitely. Fully charged 3 cell battery read as 2 cell with one almost dead cell on 1,3V. I disassembled it and found out, that few resistors on input voltage dividers are dead, some damaged, don't know why and how. I desoldered 2 highest ones (from cells 5 & 6) and replaced 2nd and 3rd and now I have FLVS only for 3 cell accu, but working again. That was smallest smd resistors I have ever seen, damned little bit**es. By the way, they are 100k value. I have placed pictures of naked FLVS and thoose resistors to files section.senzor napeti pro frsky telemetriiVery poor QC, the sensor only shows one cell voltage every time, no matter how many cells have your battery, tell me very bad about the QC of FrSky products, may I trust in the transmiter module or in the receiver?, that pieces are much more important that this sensor, if they fail, you can get injured somebody or damage the private property, HK you must do something with this issue.All voltages on my display, thats what I wanted and thats what I have now. Godd resolution and seems to be accurate so far, so I recommend this.I am afraid that mine was DOA!
On a well ballanced 3S mine reads 3.76, 2.58, 4.20 !
I have measured the cells at 3.77, 3.74, 3.74. Measured with a lab quality 6.5 digit agilent 34410A Multimeter.
Not much use so in the bin it goes!It's really bright, and accurate to 0.01 volt! It can also be use on my FrSky Telemetry system.