GT450PRO Metal & Carbon Anti-Rotation Bracket
Hmotnost ( g )
Well made but needed the slot eading a little as the Anti rotation pin was a ever so slightly tight. Other than that, very good upgrade for any 450Probellissima e ben realizzata, antirotazione molto leggera
beautiful and well made, very light antirotationStosunek Ceny do Jakoci Bardzo Dobry Polecam Daniel !!!ciao
parte di ricambio, rispetto all'originale pi leggero, ma soprattutto pi rigido e resistente
non affetto da vibrazioni
la parte in carbonio facilmente sostituibile anche con parti fatte in casa
The hole is roughly 2mm X 1.7mm, with rounded corners. As there is nothing under the hole, there's nothing on which to mount the gyro. Also, the carbon fibre fin is too thin... the anti-rotation pin can pop out during flight.The hole in the middle of piece renders this item useless as a gyro mount. Also, the carbon fibre fin is too thin so the swashplate's anti-rotation pin can pop out during flight. It looks good, but it's pretty much useless. Save your money.Needed some sanding in the trail to slide the anti rotation bar freely.Off spec, first the spacing in the carbon upright for anti rotation shaft is too narrow and must be sanded evenly in order to install with the shaft. Second the carbon upright sits too far behind and may cause the anti rotation shaft to fall out in certain height and pitch angles. Is a nice design just needs spacing and modifying so that it's functional, if you want reliability then stick with stock, if you like to be crafty then this is for you, but price is nice so no major complaints here.I have been looking at getting this for some time,
the quality is good and it fitted on my Hk 450 pro with no problems.
just make sure that it runs smoothly, i sanded it dowm with 320 wet dry
My Jr 370 Gyro fitted on well, holding powerof the gyro seems to be better.
very good looks fab again Hobby King well done on price!materiale scadente non consigliato c di meglio sul mercato