GWS 64 size EDF System
For details and thrust charts, please click below;
Suits motors with a diameter no larger than 23.9mm
This kit comes with the GWS 300H motor installed. It can be replaced with a brushless motor for better performance.
Hmotnost ( g )
very good fan unit.
highly recommended.get it you wont regret it.
do not use it for jets that weigh more than 800gm
I used this motor
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=4198This is great EDF product yet cheap price. I have flewn with 4S, 40Amp ESC and 5100 KV motor in my EF2000. So satisfy and so far never been a problem. As to reduce the load of the motor and ESC, I did cutting 3 out of 6 impeller. This make the Amp draw reduced and also make the motor cooler, but only aplicable for 4S Lipo. When flies with 3S, recommended 6 impeller as is. Good productHey HC, the link is broken so I can't find the details.i bougth this edf last week and today it was on air trusting an home made depron skyray (very light) it's very goodTop product and cheap. I will post some Running DATA soon.Ham pulverhjernen, der har skrevet det frste indlg aner tydeligvis ikke hvad han snakker om,
den nvnte motor passer absolut ikke med denne fan. Ingen af hullerne passer til denne motor, motorshaft skal vre 2 m/m, p motoren er den 2,3 m/m. Jeg taler af erfaring!!!!!!!!!!Great fan for the price. Good thrust with 3 cell lipo and 10 amp brushed ESC. Apprx. 230 gr trust for 75 gr weight with 3 cell @11 volt. it can be used with a brushed motor for more thrust. I think the brushed motor is a bonus for that fan.I have replace the motor to a BL inrunner 3800KV. I use this in a foam Fan Trainer which normally I fly just at half power. I have a 40A ESC and a 1600mAh 20C 3 Cell Lipo.An excellent product. I am very happy with mine. I think I will buy a few more. It's true value for the money