This switch has been developed over the last 2yrs and has been designed for larger gas powered models and robotics. The heavy duty dual power switch offers features never seen before in radio control, it is compact, lightweight and very affordable. It has 2 independent circuits which can be used with either one or two batteries and features failsafe switching, voltage monitoring of each battery, low voltage warning (will flash bright blue very quickly if it detects a low voltage in one of the batteries) . Very easy to program using the two push buttons on the front of the unit and the very bright blue LED indicator, it supports LifePO4, Lipo and Lion chemistry batteries.Another feature of the switch is "Sleep Mode", it uses a state of the art low power technology to maximise the life of your batteries. While in the off state the switch will go into sleep mode which uses only 0.04mA to conserve power so that you can leave the switch connected to the batteries, however it is best to disconnect if storing your model for a long period of time.
Please note: Only use 2 x batteries that have the same voltage and the same chemistry, also only use as either a receiver switch only or an ignition switch only never both together if not you will get radio interference from the ignition circuit.
• Microprocessor control, high powered switching circuits
• Fail safe switching of both batteries
• Bright blue LED for easy daylight reading
• Voltage monitoring of each battery
• Selectable battery type, LifePO4, Lipo and Lion chemistry battteries
• Low voltage alarm via bright blue LED
• 2 x 10amp constant current capability
• 2 x 20amp for 30 seconds
Input Voltage: 6~13V
Constant Current: 2 x 10amp
Max Current: 2 x 20amp 30secs
Dimensions: 36mm x 17mm x 20mm
Input/Output Leads Length: 220mm
Plugs/Sockets: JR type
Hmotnost ( g )
THIS IS CRAP..........!!!!!
I ordered 2 of these switches. I tested the first one. The red/black line tested fine. The yellow/black line burnt my FUTABA receiver up in smoke. I thought maybe the receiver was problem. I took second receiver and burnt that as well............!!!! On closer inspection I saw that the yellow/black line was fitted/soldered the wrong way inside the switch. I other words, the polarities was reversed inside the switch......!!!
I threw away bouth switches and 2 receivers...!!!!
DON'T BUY THIS..............!!!!!!Very Nice switch, works as advertised. would be nice if it included the countersunk screws though. Very bright Led can be seen from a good distance. Fitted to my 91" 3DHS Yak