Looks can be deceiving. Thisis around twice the size of a towerpro bell motor, and swings a much larger prop. Its the motor used on some of Art-techs new plane kits, which is testiment to its durability, ease of use and quality.
Required Voltage: 11.1v
Max current draw: 35A
Max power: 500W
No Load Current: 1.2A
Shaft: M4 (perfectly suited to Towerpor/GWS SF Slow Fly props)
Overall length: 66mm
Comes with mount as shown in Image
Prop Size Voltage Ampere Thrust
11x9 three blade 11.1V 20A 1200g
Hmotnost ( g )
Kv (rpm / v)
Maximální proudy (A)
Výkon ( W ):
Délka B ( mm ):
Může Délka D ( mm )
Maximální napětí ( V)
Hřídel A ( mm ):
Unit Weight (g):
Průměr C ( mm )
Celková délka E ( mm )
Odpor ( mh):
These are great motors - powerful and efficient - using these to increase the power on a number of models without breaking the bank or being power hungaryI've had very good luck with these motors. I use them on my tricopter and they have lots of power. I have 10x4.5 props, pulling around 23 amps (per motor) at full throttle. I've had to replace the bearings in one after a crash, but that's to be expected. Make sure to secure the wires to prevent stressing the the connection to the stator, I used a little bit of 5 minute epoxy, worked great.???? ??? ? ??? ??? ???
?? ?? ?????good engine
pulls 1375 grams with Turnigy 2200 3s nano and an old wood 11 * 7
I have two of these and will buy moreI use this motor in a Hk Club Trainer, with 10X6 prop and 40 ESC. I'm very satisfied with its efficiency, the plane climbs like a rocket and can performance any aerobatics with more than enough power. And furthermore a good price.Mine doesn't work at all. Quality visibly worse than my original motor from Mustang P 51 Art-Tech (same as HK Mustang).Este motor podria sustituirlo por El D4023 con Una 12/6 1500gramos esc 60 bis prrafo es sin ENTRENADOR Parecido al cesna 1,4 cm de envergadura.this motor is just amazing I am using it with a 12x6 apc prop and a 50A ESC and a 3s 3500mwh tons of thrust and power . and just near worm after a 8 minute flight thanks hobbyking its cheap and good quality and its power .my test results are
3s 12x6 57 amps i stopped a little over 1/2 throttle
where did you get 11x9 three blade 11.1V 20A from?
completely ripped off with this motorI only give 3 Crowns because.....I bought four and they came with NO information. V X A = W. your specs call for a 11.1V at 35A = 388 watts??? you say 500 watts??? at 14.8 V x 35 amps = 518 watts?? So.. what is it? I don't want to burn out my motors using 14.8V But I want the 500 watts!!