Speed Controller Features
High rate (10 KHz) switching (PWM)
3 to 6 Li-poly cells with receiver.
Dynamic braking ensures prompt prop folding.
BEC (2.0A) provides power to receiver and servos.
Over temperature protection.
User programmable Features.
Low-voltage protection - Programmable
Cutoff can be programmed for motor stop or reduced power.
Safe “power on?arming program.
Low torque “soft start?prevents damage to fragile gearboxes.
Auto shut down in 4sec after signal is lost or radio interference becomes severe.
A very high quality BESC.
Comes with a full 12 month warranty!
Max Load : 90A
Max Voltage : 6 cell 25v
As with all BESC using over 3cells, we urge you to dissable the BEC and use a seperate BEC or UBEC to power the Rx. This is the safest option.
Kapacita ( mAh )
Hmotnost ( g )
Great ESC, it takes what other known brands don't.
Just burned an Hyperion well within it's specs and will never buy one again! Just Hextronik from now on.I have tested the HEX80Amp ESC and I'm really enjoyed, very good results on my skybolt ,it work very fine with 6S lipos and a AXI 4130/20.Very good results obtained by the HXT080 in our ESC contest (highest RPM)
http://www.bungymania.com/technic/indexesc.htmlThis controller when I looked at the programing instructions I was a little confused, then I pluged it into my pc and it was so easy to program I didn't think I did anything WOW! I just had to find the cutoff voltage for the type of cells which is in the programing instructions on a chart how easy is that? 3 clicks on the mouse and a quick run test and your'e done. I like it very much.Dear Sirs,
I have tested the HEX80Amp ESC and I'm really amazed. I did a test with 5s2p Lipo (Hextronik 2200mAh), Feigao 540L9T, Feigao gearbox 5,2:1, Prop. APC-E 13x10 > about 1000W Pin and 60 Amp current. A really good choice for a plane up to 3 kg.I have 2 of this ESC and they are great, I just love the USB key and the RPM meter utility. The board design is great and have a nice construction.I recomend.