Hobbyking OSD System (Basic Combo): Main Board, Power Module, USB Module and connecting wires.
The HobbyKing OSD Combo is a quick and easy way to add a wealth of on screen information to your FPV system. With GPS coordinates, ground speed, voltmeter, temperature, and many more display functions this OSD unit will make a great addition to any FPV setup at a fraction of the cost of other GPS OSD systems currently available. It even supports an optional IR sensor and remote control for wireless function control.
An excellent new feature of this system is the "home direction" indicator which works as follows (w/addition of optional GPS module *sold separately):
"If more than 10KM/H or equivalent in MPH speed is measured by the GPS for not less
than half of a second, the system will switch the operating mode from “Landed” mode to
“Taken-Off” mode. The system will always compare between the current position
coordinate and the position measured in “Landed” mode, and calculate the “Home
Direction”, hence advises the pilot where the plane took off referencing to the current flying
heading. If you are lost during the flight, you may always fly back to the take-off
location by the referencing of home direction arrow."
OSD Display Features (w/addition of optional sensors *sold separately):
Power battery voltage
Power battery gauge
Power battery current
Power battery consumed energy
Main Sea Level Altitude
Maximum altitude reached
Distance to home
Auxiliary voltage status
Flight recorder status
Weight: Main board - 17g / Power module - 23g / USB Module - 10g
Dimensions: Main board - 60x18x34mm / Power module - 57x13x31mm / USB Module - 45x9x16mm
Hmotnost ( g )
Total scrap. Low quality soldering, design errors, missing user support, amateur and non-functional web producer with zero support. Buying definitely NOT recommend.Hard to beat this at the price, add a GPS and for under a $100 you have a full featured telemetry set up. Watch the way that you plug in the leads to the GPS it is opposite to the other units that plug in.I am very disappointed with the quality of the Apache OSD. First time I returned whole set because low quality picture on the screen. Now main board heated up and dead with smoke after third testing use.
Now I am faced an alternative (because I have power module, GPS, USB, remote control from the set): to buy main board again or through out all set and buy something better.EASY GLIDER
FPV 900 MHZ 1,5 WATT
MOTOR 35-42 TURNIGY
ESC 70 AMP TURNIGY
AMPLIFICADOR 2 WATT EMISORA
LIPO 3600 MAMP
LENTE 3,6 MM
http://youtu.be/muigVBojSZcVery good produc and nice sellerI bought the kit without the GPS because I was going to use my own. The kit arrived in a bag with the quick instruction sheet. I had to consult the bigger manual to figure out how it was supposed to go together. Overall I think it is a good value! Here are the things to watch out for:
1. The 4 pin harness for the video was completely backwards and the white wire was the video, not yellow. I re-pinned out the connector to match the big user manual.
2. The software looses connection with the OSD after a few changes. The changes I did make did get saved.
3. The OSD got messed up when outputting on the bright setting. I had to upgrade the firmware and choose a much smaller contrast to get it to work right in my office (at night). During the day the video image is brighter and everything worked much better. The bright OSD text would offset the video voltage too high and the OSD would loose it's lock and therefore placement of the text. Luckily this only happened on the bottom portion of the screen.
The other GPS unit does work and it was stock - no special setup. I do recommend upgrading the firmware since the new options are very helpful.exelente osd. tuve un problema al principio que no veia la pantalla completa pero solo fue actualizarle y ya problema solucionado. un bajo costo y altas prestaciones.Works ok whilst around the home, will be testing it inflight tomorrow.Not satisfied!! it will fit perfectly in my trash!!!!
Manual is terrible and the software avaiable too! AEORC doesnt provide support....
Gps doesnt work and it is impossible to adjust!!!!
My first one i tried to update and it died during process...i thought that it was my fault and bought a second one...it have the same problems....
Um lixo de produto!! nao compremmm..I had problems with updating the flash memory it would not update completely which left the unit useless. I experimented & finally managed to get it all working again. Informed HK and they requested me to send it back but I had already fixed it. The TF card I bought from HK doesn't seem to work on this unit even though it has FAT format & works on my Laptop...???
OSD Operations Manual download now [1705kb] Manual download now [457kb] OSD Manual RUS Betta download now [5626kb] PAL widescreen monitor works well download now [936kb] OSD Manual Fr download now [1413kb] wiring pic download now [43kb]