Hit the high seas with style and performance with the HobbyKing®H2O Style 650EP Formula 1 Tunnel! This high performance racing boat is for the discerning boat modeler who wants to go fast.
The HobbyKing® H2O Style 650EP arrives Almost Ready-to-Run (ARR), needing just a 2-channel surface transmitter and receiver, along with a 3S 11.1V 3000~4000mAh lipoly battery to get it going. The hull has been skillfully produced with hand laid fiberglass and then expertly finished with colorful graphics that are then clear coated toa high gloss finish. What sets the H2O Style 650EP apart from other ARR boats is not just the quality of the final finish, but the sharply molded hull lines. This increases precision and tracking, important in the world of racing.
Powering the H2O Style is a 2630kv watercooled inrunner brushless motor mated to a ultra trick looking faux outboard engine. This drive system is precision CNC machined from aircraft grade aluminum and comes pre-installed. The driveline angle can be adjusted as well to suit different conditions, whether you want to run wet, or even on the ragged edge of nose high. Access your motor and battery through a magnetically secured, foam filled hatch. Included in the box is a laser cut plywood display stand, spare propeller, balloon for waterproofing your receiver, and a roll of waterproof hatch tape for double security on that battery hatch.
For performance and good looks at this killer price, the HobbyKing® H2O Style 650EP F1 Tunnel can't be beat. Rule the waves in style!
• Almost Ready to Run - Just install battery and your own radio
• Light weight, hand laid fiberglass hull
• Bright colorful graphics pre-applied
• High gloss clear coat finish
• Fast access Battery hatch
• Watercooled brushless motor built into faux outboard motor
• Laser cut plywood display stand
• Includes waterproof tape, spare propeller, and balloon for waterproofing your receiver
Motor: 2840-2630 Brushless outboard motor
: 60A Watercooled Brushless w/ XT60 connector
Servo: 1 x standard size
2 Channel Transmitter and Receiver for Surface
3S 11.1V 3000~4000mAh Lipoly Battery
Hmotnost ( g )
Super fun boat. Just remember to remove and grease the flex shaft before you put it away or after 4 battery packs or so. I am using a 3 cell 4500mah 35c lipo. Had to modify the battery tray to fit the longer battery. The boat performs well with the stock propeller, but really moves with a 2mm larger aluminum prop. The boat will nearly sink if you crash right, I suggest adding some foam inside the haul to keep it afloat.Let's just say... WOW. HK you guys out did your selfs on this. Recived my H2O today. Shipped fedex. The box didn't even looked touched. Opened the box to find another box with packing bubbles around it. Opened that box to very nicely packed boat. The scale looks of this boat are amazing. The quality far exceeded what I was expecting. The only thing that was a downer for me is the battery straps are way to short. I don't have a single battery that these straps will wrap around. But that isn't issue for a well seasoned hobbiest.. I even like this better than my 80mph genesis. It's just that good.Just received. The boat runs well I would. Like to.get a CNC prop for it to see what speeds. I get out of it If you can get one get it I have the rocket. Hull too runs as good as. the H2O I will have A buddy of mine one of them