HobbyKing® ™ 60A Sensored/Sensorless Car ESC (1:10) with built in cooling fan.
Enhanced throttle response, excellent acceleration, enhanced braking and throttle linearity
Programmable with a HKSS programming card.
Automatically detects the number of cells within the battery pack.
Multiple protection features, Low voltage cut-off protection, over-heat protection, throttle signal loss protection and motor jammed protection
Compatible with HobbyKing® ™, NOVAK, LRP and ORION Sensored brushless motor
Cont./Burst Current: 60A/380A
Resistance: 0.0006 ohm
Suitable Car: 1/10 & 1/12 on-road and off-road cars / trucks
Suitable Brushless Motor: 5.5T On road / 8.5T Off road (2s) 10.5T on road / 17.5T off road (3s)
Battery: 5-9 cells Ni-xx (NiMH / NiCd) 2-3 cells Li-Po
BEC Output: 6V/2A of switch mode built-in BEC
Motor Type: Sensorless and Sensored brushless motor
Hmotnost ( g )
What the hell? HK sells a ESC which can`t programm without a Card? now the joke - HKSS Programmcard is out of stock!!! or cant sent to you from.........Cheapest ESC that I have found that will work with Novak sensored motors. Hooked it all up and works great.I have 3 of these installed in my 2 Team Durango DESC210's and a DEST210. Very nice power and torque. No problems so far. Cannot beat the price.well I gave it a try today it 50deg out side and got to say it ran really good. the temp was 80 on the esc after ten minute running but it was only 50deg out.I am running a turnigy trackstar 10.5 motor that was 76 deg after 10 minute running gear ratio were 100 t spur and 35t pinon. The drag brake work good got set up like a brush motor. I set the brake at 60 percent don't want to brake to hard on a belt drive car the program card work great set it up in about 2 minute for the price it a great little speed control and very small work good in mini 1/10 car.
works perfectly with motor Turnigy trackstar 8.5T .
kyosho Sandmaster tested .
although there have XCar stickers stuck on is not compatible with the USB key Product ID: 351000018
I expected the hkss 150a programming card for the settings adjusted
I bought the 30a before, this one is completely the same in terms of size and looks, also uses the same programming card. It's small and fits very well in 1:10 cars. The fan is hearable, but not too loud. I would say great value for the money.I bought two and after two years still work very well
needs his program card
I've had two of these that I used for racing stock class 1:10 indoor Clay offroad. Both of them died. One might have shorted something vital out when the sensor cable got damaged but the other just got intermittent after about a month and died shortly after. I think I am going to try a Xerun for a while and see if they hold up any better.I've had two of these for two years now, on a losi22 buggy and a team associated t4.1 stadium truck. Both running trackstar 9t's on 2cell batteries. Both work very well, have seen some damp conditions and yet have never let me down, power delivery seems quite linear and always seem to run pretty cool. Great product for the priceNice Small Sensored esc, Works NICE in my 1/10 Drift car, For a Lovely price, I get Loads for my money, THANK YOU HOBBYKING!