Here it is!
The DIY kit of the popular 2730 motor.
Wind for Kvs from 900 to 6000rpm/v
Wire Guage: .44mm
Weight of motor cannot be determined as it comes with extra wire, shrink wrap etc.
11 Turns Y config 8 magnets for 1700kv
14 Turns Y config 8 magnets for 1300kv
Experiment with turns and magnets to make your own performance motor.
Getting the wire tighter and neater than any factory would care to offer, will enable you to squeeze maximum power from this already stunning motor!
Excellent for small foamies especially GWS pico planes.
The towerpro engine mount shown here can be used for this motor;
Hmotnost ( g )
Super stuff to DIY and understand motor basics, doesn't come with any manual, however they are available in the files tab, so go right ahead and do some exprementVery noce and cheap - good for "learning brushless motors".motors came in good time,they were complete and the build went good. dont really have any serious complaints and would buy again. used all 16 mags 13T wye 1209KV 11.27 V it doesnt like small props rather anything from 8-10 but watch the heat. the motor ran very smooth, looks like another version of the blue wonderj'ai acheter 2 kit moteur ordre:2001813847 code1h25393858 que j'ai recu pas de support moteur, pas de repere aiment, et surtout pas de notice de cablage donc impossible de faire ce kit dommage
bonne fete a tousGreat little kit to learn the "ins and outs" of a brushless motor. Fit and finish were very good on my kit and all parts could be pressed together by hand with the help of a flat (soft) wooden surface.Very nice set, especially since the 1500kV is sold out. I use them in my Epp Shockfliers.Three minor bad things first, the sticky board it comes on is horrible. should be in a small box or something. second, The can is hard to press together. Third, no instructions. After that, what fun!! I wound 8T delta.
Tested using 3s 25C hyperion lipo and CC t-bird 9
22,300 rpm @ 11.88V 4.40A APC 4.2x2
18,800 rpm @ 11.70V 9.66A APC 4.7x4.25
Used on my Fun Foam F-15 profile pusher. Flies 55~60mph. Comes down cool! esc is only warm!Good and cheap Motorparts.
Very good quality and easy to build.This is a good site for winding information of brushless motors.
http://www.bavaria-direct.co.za/models/motor_info.htmlook fun and interesting to diy a motor on my own.
so brought one to try. qualtiy and packaging look good.
will update when i gt it done and working.