Insta-Cure Plus Gap Filling Pocket CA 3/4 ozINSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Hmotnost ( g )
I am a bit disappointed with this glue. Each time I used it I had to wait about 30 minutes before it stopped leaking. Much too liquid. But once in place and dried out, holds the parts very veyr good!need to wait a while before it starts. but it works very wellusefull, easy aplicationgreat glue!! I have used this formula for a few models and it hold well and fills in the little blemished to make a nice smooth finish, also if you want to glue your hands to balsa wood this works well.This glue never lets me down. Works great with all my depron planes.glues aren't just glues
this is CA glue at its best
would buy againESCELENTE PARA TAPOR AGUJEROS EN LOS AVIONES DE MULTIPLEX Y SIMILARES CUANDO PIERDES ALGUN TROZO POR LOS ACCIDENTESI've bought many NHP CAs from Hobbycity in the past, and this seems to be on par, if just so slightly less powerful than them. Works well with Flashtac accelerator.