Insta-Cure Super Thin CA 1/2 ozINSTA-CURE has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.INSTA-CURE is a highly refined CA which, combined with it's freshness, gives a guaranteed 2 year shelf life.
Hmotnost ( g )
Quality Value OverallBeats the pants off the hobby shop ripping me off. Quality Value OverallCertified Buyer Ratedtorro Quality Value Overallgreat, its thin like water. Quality Value Overall Quality Value OverallThe best thin glue! I do not use other more since I know Insta Cure Quality Value OverallCertified Buyer RatedInstech Quality Value OverallInsta cure is the right name! grabs in about 1 second and does not let go after 3. Quality Value Overall Quality Value OverallGood glue from wheels. Quality Value OverallCertified Buyer RatedAllanchiass Quality Value OverallNothing bad .Just normal incoming Quality Value OverallCertified Buyer Rated__HaKK Quality Value Overallgood for wicking CA in tight places Quality Value Overall Quality Value OverallGreat Thin CA,Cant go wrong with the price Either Quality Value OverallCustomer RatedDamage333 Quality Value OverallHey Hobby King, Good product, but thanks a LOT for putting your obnoxious inventory barcode sticker right over the label. I ordered 5 similar products from you "SuperThin", "Gap Filling", "Extra Thick", "Debonder" and "Accelerator" and all of them had the sticker placed right over the label. I can not tell one from the other. Oh, and good luck removing this sticker without pulling up the label under it. Really... I understand the need for inventory stickers, it's how you guys run your operation, I get it, but come on there are plenty of other places this sticker could have been placed that would not have been a hinderance the consumer. Here is a link to a picture of all 5 bottles (I have started to try to remove the labels from some of them, originally they were all as bad as the bottle on the right)... http://i43.tinypic.com/mikkuu.jpg Quality Value OverallCertified Buyer RatedTieto Quality Value OverallThis really is super thin CA, and soaks through balsa and ply in seconds. Be aware of fumes that are created (Don't have your face right above the place being glued.) Excellent for CA-hinges, holds really well. No need to use accelerator as it sets in seconds. I use it to reinforce ply motor mounts and other places in balsa planes that like some reinforcement. Quality Value Overall
Štítky oddělujte mezerou. Víceslovné uzavřete v apostrofech (').