The HK Pilot Micro Power distribution and power module in one is simplifying your setup, reducing points of failures and makes for a clean and tidy install. The ALL-in-One has a PDB and 5.3V UBECs, Voltage and Amperage sensors all integrated on a standardized 35mm (30.5mm) mounting package.
The power distribution side is on a standardized mounting and is rated at 60A of current and more than enough contact points for a Mini Quadcopter. The Amp and voltage sensor are compatible with HK pilot FC and APM/Pixhawk FC with the standardized 6 pin connector. The ALL-IN-ONE is 4s capable
PDB/5.3V 3A UBECs/V and A Sensors all in one
Standardized sizing 35mm (30.5mm)
HK Pilot and APM/Pixhawk compatible
UBEC Current: 3A outputs
Power input: 2 x contact points for Voltage/current monitor
Power output: 8 x contact points
Mounting hole: 30mm*30mm
Cells: 4s max
BEC: 3A 5.3v
V/I Sensor: APM and HKPilot compatible
Mini UBEC power distribution board *1
6pin cable(1mm pitch) *1
Hmotnost ( g )
First off I wasn't very impressed with the PCB being only 1mm thick and the hole spacing is more like 30mm and not 30,5 as specified. Functionality seems to be good, handling about 40A, 5V line is reasonably clean with minor switching noise, voltage sensor ratio is 1:10 and the current sensor outputs in my case about 0,08V per A. The connectors used are 6pin JST-SH.