The R9000S is the best in class Synth receiver available today. With auto scanning, PCM/PPM auto-select, JR/Futaba auto-select, 9 channels and a high quality design.Spec.
14ms and 3.5ms output for analog or high-speed digital.Anti-jamming & frequency amplification
Worlds smalled PLL (PCM(8Ch) / PPM(9Ch)
Kapacita ( mAh )
Hmotnost ( g )
Seemed to work well at first. Linked up fine with my Futaba T7CHP in PCM1024 on my HK 450. BUT then had a radio glitch resulting in very bad crash, which SHOULD NOT HAPPEN on PCM 1024. Testng on the bench I later found that FAILSAFE DOES NOT WORK. When signal is lost, all servos reset and throttle goes full. I give this 1 star because the whole point of having PCM1024 is the failsafe and the ability to keep servos in last position.Picked up one of these for my Trex500. Using a 9CHPSuper in PCM 1024 with it. Works fine. Has a sync light for easy setup. The instructions are hilariously bad but I managed to figure it out.
One star removed due to it losing PCM sync with the Trex500 whenever I rubbed the heli with a metal screwdriver. Must have caused enough nearby noise to affect the RX. Takes a second or two to reacquire after such a loss. No failsafe as far as I can tell.Estoy usando este receptor para fpv con una radio futaba pcm 6canales, hasta el momento llegu a 1400 metros sin problemas con la antena del receptor alargada.
Me gustara saber si alguien lo usa en fpv y si me pueden indicar como conectarle un sensor RSSI.
Graciasfunciona con la radio Wfly 9ch? / Does it work with the radio WFLY 9ch?Super rcepteur, je l'utilise avec un Futaba T12 FG et monter dans un planeur de 4m, reconnait parfaitement les modes PPM et PCM, facile de programmation.
Merci Hobby de nous proposez des rcepteurs d'aussi bonne qualit avec des tarifs dfient toute concurrence...i have problem with electric JHK SPEEDCONTROL FOR MY HK250 it only start to accelarate middle way in accelarion stick on my futaba 7 cap.
I tested another SPEEDCONTROLS AND IT IS THE SAME.
for other things it is SPECTACULAR.WHAT I CAN SAY MAGNIFICIENT... very best receiver ever test with my futaba 7cap dont expend EXTRA BUCKS...You may be very disappointed when you first get this receiver and try to set it up using two different manuals included with the receiver.
To make it simple.
1. have the button pushed when you plug in the power. If the red light isn't solid on, then you need to start again.
2. press the button one time, fast click and the receiver will start to scan, may do many fast flashes and will finally get to your frequency and turn blue.
3. Hold the button down till you get a solid blue light.
There is another setting series to set the digital output frequency. Perhaps from the above you can reread the manual and figure out how to set it.
Sistema complicado para configurar, Manual muy corto y no bien explicado. La calidad es buena, pero jodidoVery poor range compared to stock Futaba PCM receiver.
Lock out once at 300m otherwise OK up to 500m on 20 flights.
Tested this RX against stock Futaba R129DP at the same time, with the same transmitter. With the RX antennas pointed straight up starting at 5 feet and going to 8 feet and the Futaba 7UAPS transmitter antenna completely collapsed and through a small stand of trees the R129DP got 1200 feet. R9000S and no trees got 200 feet.