MultiStar ESCs are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If your starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These high voltage ESC's feature a very smooth yet linear throttle response, without sacrificing a rapid, crisp, response to any throttle input. Safety is not forgotten with all Multistar Esc's featuring adjustable battery LVC (set battery type to LiXX to disable LVC), stalled motor (overload) protection, signal loss shut-down and safe arming.
All Multistar series ESC's come with bullet connectors installed that are suited to the ESC's rated power handling. This allows for plug and play convenience by simply adding the appropriate battery supply splitter (3,4 or 6 ESC) and motor lead extensions from the Multistar modular accessory line. What could be simpler?
All Multistar ESC's feature an ATmega MCU that opens the door to customizable firmware - for those so inclined! or alternatively a programming card can be used with the installed software for quick and easy setup with the pre-flashed software.
Please refer to the related items below for a solder free multi-rotor power solution to suit your next multi-rotor project.
• Smooth and linear throttle control
• Fast response to throttle input
• Atel MCU
• Stalled motor protection
• Throttle signal lose protection
• Safe power-on (throttle lockout)
• Support 480Hz+ high refresh rates (up to 499hz)
• Compatible with programming card
Constant Current: 60A
Input Voltage: 2-10 cells LiPoly
BEC: None (OPTO)
Hmotnost ( g )
The firmware that comes delivered with this ESC has the governor mode turned on, which is fine for helis. I wanted to use this on an airplane, so the governor mode needed to be turned off. The name of this ESC includes "BLHELI", so I figured I could use the BLHELI programming guide to turn off the governor mode. However, the firmware delivered did not match the BLHELI firmware function at all. So I cut the covering off, traced the 6 required ISP lines (MISO, MOSI, SCK, RST, GND, VCC) and soldered on temporary connections into a USBASP. Then I used the BHHELI suite installation software and selected the appropriate firmware "MULTISTAR 40AV2 MAIN" (same firmware for 40A or 60A ESC) and programmed that to the ESC, then changed the configuration to GOVERNOR OFF. With all of that done, I now have a fully functional 60A HV ESC that works fine with an airplane.
The BLHELI suite and firmware can be found here: