Pin Horns 21x11 4 hole (5 sets only)Note: In the image shown 2 sets, the bag contains 5 sets only.
Hmotnost ( g )
Devido ao tamanho do pino de fixao bom medir e cortar o excesso antes de perfurar o isopor.It's very hard to get the pins through the retainers.
Es muy dificil pasar el perno/clavija por el sujetador.I must be missing something. The horn and keeper are rugged. But the design of the keeper seems flawed. I wanted the flat side of the keeper against the foam. I was unable to press the keeper over the pin by hand, only if I could fit a pliers onto it, and typically there's no room to do that. I could push the opposite side, the rounded side, over the pin, but it looked obvioiusly wrong. The only way I could make the keeper work was to drill out the hole first. Of course, that removed part of the latching feature. Instead of a simple pin and keeper that can be easily inserted and latched by hand, it became an unnecessary struggle. The price is good, but some tweaking is needed to get the design to work properly.Good for small foamies but max distance from control surface to joint hole is onli approx. 8mmGood for foam airplanes. At this price, you cannot go wrong by having some as spares.This is must have for all depron flyers. Easy to mount and use. ALso holes are different so it will fit for various thickness wire.to escrevendo pra ganha bonus hahahahahahaThese horns are thick and good quality. I would just drill hole in control surface and epoxy them in with the included plastic backing.Great item for the price strong and depenpable. Works well on all foamy, either with Expoxy or Hot Glue. haven't tried CA as yet. Good price quick and easy.The absolute best horn for foamys. It has enough length to get out over the hinge line. I throw away the plastic backer and just make a small square of depron and use CA or a drop of epoxy. These horns don't break out.