Print-Rite DIY 3D Printer – Heat Table (200 x 200mm)
This Heated Table (or bed) is a must for your existing Print-Rite DIY 3D Printer as it helps to improve the quality of your printing when using ABS, PC, and other high temp filaments. It is easy to assemble and fits straight into the print bed.
Size: 219 x 219 x 1.6mm
1 x Controller
1 x Heat bed
1 x ABS glass
4 x Silica films
2 x Clips
Hmotnost ( g )
Update on this heater bed:
The heater bed wasn't heating up all the time. I ended up removing the connector to the heater and checking the continuity of the wires going to the plug and found that the thin power wire to the plug was not fitted correctly and wasn't making contact.
So check the continuity of all wires to the plug from the controller board when you get your heater bed.Heater bed draws a maximum of 63 watts on my tests and can only be heated to a maximum of about 110c.
The duration of the heating will not last for the duration of long printouts. The time is not known yet, but will update later.
I've got a 250 watt power supply powering both the heater bed and the printer without any problems, so far.