The Tablet Transmitter mounting bracket is an excellent solution for pilots who prefer to use
there Tablet as an FPV monitor.
The mounting bracket features a butterfly style clip which allows you to mount your Tablet in seconds. The rubber inserts provide a super tight fitting to ensure your Tablet cannot slip from the
The assembled mounting bracket is screwed to your transmitters carrying handle via the supplied fixtures and fittings. The mounting bracket can accommodate Tablets with a maximum width of 200mm.
• Butterfly style clip for fast mounting
• Non-slip rubber inserts prevent your Tablet from slipping
• Accommodates Tablets up to 200mm wide
• Fits transmitters with bar type carrying handles
Material: ABS Plastic, aluminum swivel ball joint and Brass thumbscrew
Hmotnost ( g )
The same happened to me; I've had to glue the aluminum rod to the ball ends together with epoxy, let's see if that works. Still trying to figure out how to make the whole system steadier, maybe some rubber bands will help.
The support required a bit of plastic trimming to match my futaba radio, no big deal.
A good idea, but poorly finished. Hope a "v2" appears with this issues corrected.Avoid this item at all cost, it simply cannot handle the weight of a little tablet! The thumb screw bottoms out in the included nut and will allow the tablet to tilt back and forth. You have to really tighten everything for it to stay in place and even then it will move around easily.The small ring that tightens the bottom of the shaft broke just now (so it's useless) and the aluminum rod ends are not glued properly and come loose. Terrible, just terrible, I'm filing a customer complaint right now.