For the distribution of power from the flight battery to your six ESC's, this 24k gold plated hub offers a very neat and efficient solution. It has 3.5mm bullet connectors and 6x 3mm terminals on the back. It is stable at high currents and has minimal power loss.
• High efficiency
• Neat instillation
• 3.5mm Bullet connectors
• Easy solder 3mm holes
• All necessary hardware included
Hmotnost ( g )
these are really light and neat. ut really wonder why they didn't make those with 2mm or 3.5mm bullets holes so you can connect and disconnect your esc easily? I don't think it'll make them any heavier or bigger if they do. lets hope some smart company take this advice and make a version that you can connect and disconnect from it easily ;)This is a little gem with a jewel-like gold finish. The center connection of each half fits a standard 3.5mm bullet connector that can take AWG #12 wire. The six solder sockets for the motor wires on each piece are likewise large enough to take a #12 wire and have slot openings to the periphery through which solder can be flowed. It is probably the ultimate in terms of compactness and IMO offers a much more secure and reliable electrical connection than the printed wiring board power distributors. A winner for sure and will be my standard power distributor going forward. My only suggestion for improvement is to provide an additional port or two for lights and other accessories.Very useful for DIY multicopter projects.trooppo piccolo inutile si surriscalda e basta