The TracksStar Easy Fit Brushless Motor Connectors are the new "must have" item for anyone who has an R/C car. These incredibly handy connectors have a screw that threads through a connector that is soldered to the motor's wire tabs and into a corresponding connector on the power wires. This means when you want to change motors you simply unscrew the existing leads and screw them to another motor. You only need to solder to the motor once which significantly reduces the chance of damage to the sensitive electronics inside. Each pack contains 3 motor side connectors and 3 parallel and 3 right angle wire connectors so you can vary the way the wires run from your motor. Once you have tried this product you will never go back to the old way of wiring up ESCs.
• Suit for 540size sensored brushless motor
• Wire can weld as stright/45 degree/90 degree out
• Fit for 14 and 12 AWG wire
Screw size: M2x12mm
Hmotnost ( g )
Diese Dinger taugen berhaupt nichts, ltet die kabel bitte direkt dran, es gengt nicht wenn das ein bisschen hinklebt.Geltete Dinge darf man mit einer Zange nicht so einfach abziehen Knnen.not easy to use, they work well though.The Trackstar motors can be hard to solder but these connectors do not really improve things. Soldering them to the motor is almost as tricky as soldering wires directly. The only good point is the motor can be easily disconnected. I wouldn't really recommend them.this picture is not correct. I have three trackstar motors and none of them have soldering connectors like the motor in the picture. So soldering the connectors is not so easy