Hardcase Lithium Polymer pack for high-end performance brushless electric or modified brushed motor cars.
Big capacity and C rate give up to 250A for 20seconds and up to 300A for instant throttle punches.
Hard case pack ensures the battery wont get damaged from the g-forces and shock associated with R/C vehicles.
40C is the genuine rating of which the battery will hold voltage well above 3.4v
Other vendors claim their packs to be 40C when in fact they are not. Based on other vendors calculations this would be a 50 or even 60C pack.
All TURNIGY packs are resistance matched.
Now officialy approved by ROAR for race use!
Minimum Capacity: 5000mAh
Configuration: 2S2P / 7.4v / 4Cell
Constant Discharge: 40C
Peak Discharge (22sec): 50C
Pack Weight: 326g
Pack Size: 137.5 x 46 x 25mm
Charge Plug: JST-XH
Discharge plug: 5.5mm Bullet-connector
Model no: T50002S2P40-R
Hmotnost ( g )
Kapacita ( mAh )
Výboj ( c )
Délka -A ( mm):
Výška - B ( mm ):
Unit Weight (g)
Max Charge Rate ( C ):
a inovation in rc hobby, awesome lipo charged it over 60 times on old model, still give me an insane burst use it almost 1 yearPeace or crap. Dont buy any turnigy batterys I charge even with store mode on my Hyperion eos 1420 charger and afte 4-6 weeks it is dead. And hobby king told warranty 30 days.Excellent quality with excellent price.
I am using in my engine Velineon slash and durability is approximately 10 minutes while maintaining its performanceThese batteries are huge. The solderings are improved. The weight is almost equal to the given specifications. I liked the battery.All batteries are charged about 50 to 60pcnt and no single cell is defect. Bought 8 pieces of them.i got my battery about 3 weeks ago and cycled it about 15-20 times and seams to be a true capacity rating.i run this in my stampede alot and i beat on this truck and i have not broke the case as some have claimed.i would buy again and again, thanks hobby kingGot mine today. Packs weigh an average of 330g each. The cases are slightly smaller than the old 2S2P 40C 5000 mAh packs, and fit perfectly into the smallish battery bays of my XTM XT2E buggy. The 10AWG wires were much easier to solder up as compared with the 8AWG wires of the old packs. I'm stoked!