The Turnigy AE series are based on new powerful microprocessor.
The new CPU means ultra fast sync timing, crisper throttle response, less battery load and reduced FET heat buildup. Also there is a separate voltage regulator IC for microprocessor providing good anti-jamming capability.
Output: Continuous 25A, burst 35A up to 10 seconds.
Input Voltage: 2-4 cells lithium battery or 5-12 cells NIMH battery.
BEC: Linear 2A @ 5V
Control Signal Transmission: Optically coupled system.
2 Pole: 210,000rpm
6 Pole: 70,000rpm
12 Pole: 35,000rpm
Size: 50mm (L) * 26mm (W) * 12mm (H).
High performance microprocessor brings out the best compatibility with all kinds of motors and the highest driving efficiency.
Wide-open heatsink design to get the best heat dissipation effect.
Improved Normal, Soft, Very-Soft start modes, compatible with aircraft and helicopter.
Smooth, linear, quick and precise throttle response.
Multiple protection features: Low-voltage cut-off protection / Over-heat protection / Throttle signal loss protection
Programable via transmitter
Brake setting (we recommend using brake for only folding props applications)
Battery type(Li-xx or Ni-xx)
Low voltage cutoff setting
Factory default setup restore
Timing settings (to enhance ESC efficiency and smoothness)
Soft acceleration start ups (for delicate gearbox applications)
Low voltage cutoff type (power reduction orirnmediate shutdown)
Factory default settings:
Battery type: Li-xx (Li-ion or Li-Po)
Low voltage cutoff threshold: Soft cut-off (2.6V)
Timing setup: Low
Soft Acceleration Start Up: Normal
Low voltage cutoff type: Medium
Hmotnost ( g )
The first one of these I bought. Cut out (killed power, once killed all controls) at random times during flight, twice at launch. Replaced with a proven esc on hand and system worked fine. I'm 0 for 1 on these.ESC basique, mais qui joue tr?s bien son r?le. Fonctions de base, programmation avec la radiocommande uniquement car il n'est pas reconnu par la carte de programmation Turnigy Plush, dommage.petit prix, je recommande.Good esc for the priceI buy this esc and I plug it with the battery and the motor, after I turn on the power and I program the esc. Finaly I try it in my hand, and after few seconds, the reciever reset like when we plug the battery.
I also try it with a HobbyKing esc 20A and it work perfectly!Heavy duty heat sink, this ESC throws tha powah!Excellent ESC. I have started using these in my smaller planes. Have not had any trouble with them. My son also uses these. No problems. Another fine product from Turnigy.Connected this today just to be sure it was working fine and item came with full instructions and performed fine. This items has a heat sink on it that I will likely partially expose to allow better airflow over the fins.This is strange ? All servos C929MG work fine with a Orange Rx But after abut 60 seconds everything goes dead ??? I have tried different 2200mha 3S lipos and still the same issue ? I have to unplug everything and start again any one else had any similar issues ?
Regards MarcBought this for the Hobby King Yak-55. Does not work with 4 servo's - only with 3. The BEC is rated at 2A. When connecting the fourth servo (or Y-Cable to the fourth) the ESC shuts down. The 5,6V line drops to 2,6V and the servo's jitter and the throttle does not work. If you are planning to set up a plane for acrobatics, it will be better to have BEC current of 3A or more. Each of the servos' I used peaked at 450mA and if all four peaks at the same time and you add the 100mA the receiver draws, the margin towards the 2A BEC is not enough. Little dissapointed here, but I guess I should have read the specs more accurately.I just bought four of these for my quadcopter. Three worked fine, the fourth smoked after about thirty seconds at idle speed. I put back one of me old ESC's and the quad is working fine now. It looks like it shorted out inside. Noe I have to figure out how to get it replaced from Hobby King.
Reference model download now [468kb] HK manual TAE ESC download now [109kb] Manual download now [945kb] Theunsie s setup manual better explaine download now [4kb] Programmation SÃ©rie AE en FranÃ§ais download now [216kb] Programaton ESC sÃ©rie AE download now [216kb]