Turnigy SK3 Motors are the next leap forward in motor quality and design. We instructed the engineers to source the best quality magnets, bearings and materials available to them and develop a motor that would not only rival, but surpass the quality of many leading motor manufactures on the market today.
The result is an efficient, high caliber motor using quality double shielded bearings, sintered Neodymium magnets and a string wound stator ensuring an accurate and consistent winding each and every time.
The Turnigy SK3 motors are suited to modelers who are seeking a quality brushless motor without compromise.
Voltage: 3~4S Lipoly
Internal resistance: 0.022Ohm
Max Loading: 54A
Max Power: 755W
Shaft Dia: 5.0mm
Bolt holes: 25mm
Bolt thread: M3
Motor Plug: 3.5mm Bullet Connector
Hmotnost ( g )
Kv (rpm / v)
Unit Weight (g)
Maximální proudy (A):
Odpor ( mh):
Maximální napětí ( V)
Výkon ( W )
Hřídel A ( mm ):
Délka B ( mm ):
Průměr C ( mm )
Může Délka D ( mm )
Celková délka E ( mm ):
nice motor, very strong, go on my EF Vanquish MKII, see my test on file tab, with a Turnigy Stand V2
Thanks all, good flighthello,
nice motor, strong and power, see my simple test on file tab, make with turnigy thrust stand V2
Good FlightWorks very well on a wing 4s 9x6 prop 85A esc 700 watts and very cool on landing. Ill try to post a video. I own 15 of them so far and all work.
-https://www.youtube.com/watch?v=bkQVaUEgC3E-Very high quality, a big step up from the NTMs. Nice smooth run, good accessory pack. Tested to 69A, 1002W with a 4S 45C nano-tech and a 12x6E prop, does hardly get warm. Recommend.
Very good and strong motor. Makes very little noise. And is reay worth his money. I wish I had both it mutch earlyer. With a strong 70amp esc and 12x6 propeller a great combination
Fantastic motor for my Multiplex Tucan - not worst than AXI2820/08. Comparing both motors in practice I'm prefering this one.Excellent motor, has lots of punch using 4S and 11x8 folding propFantastic motor for the price. I purchased this to replace my aging hyperion. Running a 9x6 pusher on my skywalker. Loads of thust and will cruise at around 45kmh and be pulling under 10a. I chose to use a 60a controller (yep60) so there is not much heat to worry about. At full power it is only pulling 40A. Running 2x 5000mah 3s nano tech in parallel to give 10000mah total. I can cruise for an hour if I watch my consumtion and get great footage. Will buy another to keep as a spare.Great motor. I use one on a phantom FPV wing running 3s ,10x6 prop and a 60A plush esc. This thing has got LOADS of power and the build quality is outstanding. It's a a larger motor though so it is a tad on the heavy side compared to say the ntm 3536 series.
I have just ordered a second one of these to power my "wicked wing", which has been setup for FPV.
5 stars.Perfect like every SK3 motors. Maybe I'm lucky, but I use many SK3 engines and no one disappinted me.