Turnigy® dlux SBEC ESCs have set a new bench mark in quality and performance. Each ESC uses a twin PCB design separating the motor power supply, MCU and SBEC. This design allows for optimum component layout on each PCB and provides the ideal configuration for heat dissipation and thermal efficiency. Both PCBs are enclosed in a full aluminum heat sink casing to ensure maximum heat dispersion. All Turnigy dlux ESCs can be programmed via a programing card or by transmitter. Clear and easy to understand instructions are included.
*Now featuring data logging viewable when used with Turnigy dlux programming box.
Data logging display parameters:
Motor Run Time
Power on Time
Motor Pole Number
Max Motor RPM
Max Cont. Current: 70A
Max Burst Current: 85A
Max BEC Current: 3A
BEC Voltage: 5.5v
Max RPM (2-pole): 200,000rpm
Size: 69 x 33 x 23mm
Motor Plug: Female 4mm bullet Connection
Battery Plug: Nil
Extremely low internal resistance
Very low operation temperature
Over temperature protection
APEC MoSfets (Taiwain)
Battery Type: 2S~6S
LV Cut off Type (Ignore, Reduce Power, Stop Motor)
LV Cut off setting (2.5~3.5v in 0.1v increments)
Timing (Auto, Very Low, Low, Normal, High, Very Hgh)
Active RPM Control: On/Off (Governor Mode)
Default factory settings.
Battery: LiPo Auto Detect
Low Voltage: 3.2v (power down motor)
Note: Programming box now available, check the related items below.
Always keep your phase wires as short as possible, or ESC will lose timing/stutter.
Hmotnost ( g )
Well built with outstanding aluminum cooling.I feel good, I have 3 with one ordered two days ago.
I have the programming card that very useful, does not heat never use Sebart Sbach on 4S, 6S on Sebart katana, katana 4S on hobbyking!
lightweight and well-made, compact, convenient to use programmer on-absorption models to control engine speed and amperage consumption.
very pleased to have purchased it, I think it'll take even the 100AGute Reglerleistung, Temp auch Ok, Achtung nur auf Bauhhe. Musste aufgrund der Hhe des Alugehuse einen anderen Einbauplatz whlenVeramente facile da usare e fa quello che dice la pubblicit?? ????. ??? ??? ??? ?????? ???? ???.Lakpletbe, pince kivtelvel, nem kerlt vz, ez volt az egyetlen pozitvum. Kertekben, mellkpletekben krt tett a vz, egy zletbe kerlt 8-10 centi, a Klapka utcban pedig fertotlenteni kellett, mert szennyvz kerlt ki a csatornbl. Tizent esetnk volt, de ezek egy rszben egsz utckat vz bortott, fakidols is okozott problmtGewicht 85,18g incl. Kabel und Stecker,
Anschluss Akku 12 AWG 11,5cm
Anschluss Motor 12 AWG 9cm mit 4mm Golkontaktstecker
Empfaenger 22,5cm inkl Stecker
68,2 x 33,5 x 24,4 mm sorgfaeltig ausgefuehrtGeniale Features - Rubustes Teil - Governor Mode funktioniert gutI have installed Turnigy dlux 70A SBEC Brushless Speed Controller in Tucano 60. The plane is powered by 5s 5000mAh LiPo with Turnigy 5055 600kv motor and constant speed (variable pitch) 3 blade 12 inch propeller. The main reason I bought it ESC was the governor function that is required for constant speed propeller. At 5s LiPo Im running the prop at 9000 rpm with variable load from 5A to 55A, and governor is keeping the constant rpm speed without any problem.
If I set the speed to 4000rpm without much load the speed oscillates about 1 cycle per second at first few seconds but then it settles at constant speed. This is not a problem, just a note.
I have setup very slow spool-up and it works awesome. It takes about 10 second to get to 4000rpm, about 20 seconds to 9000rpm. After governor gets to the preset speed then the throttle response immediately changes the speed (no slow spool-up or spool down). So, as expected, the slow spool-up works only for starting the engine.
I programmed this ESC using radio (no programming card). Programming instruction is sufficient but dont read the musical tones like you would read the music. Musical symbols illustrate what kind of tones you may hear, not a musical score for the music you will hear. Bust after running few cycles of entire programming sequence you will learn what symbol represents each music. After that the programming is as easy as 1-2-3.
In general I am very happy with this ESC, especially in my setup. YoFor my money this is a great ESC.
Used with a Turnigy .32 outrunner(770kv)
and a 4s 3600 mah turnigy battery
all in a Superstar 40. I have over a years worth of trouble free weekend flying : )