Turnigy® dlux ESCs have set a new bench mark in quality and performance. Each ESC uses a twin PCB design separating the motor power supply & MCU. This design allows for optimum component layout on each PCB and provides the ideal configuration for heat dissipation and thermal efficiency. Both PCBs are enclosed in a full aluminum heat sink casing to ensure maximum heat dispersion. All Turnigy dlux ESCs can be programmed via a programing card or by transmitter. Clear and easy to understand instructions are included.
Max Cont Current: 80A
Max Burst Current: 95A
Max RPM (2-pole): 200,000rpm
Size: 52 x 33 x 23mm
Motor Plug: Female 4mm bullet Connector
Battery Plug: Nil
Features: Spark Eliminator Lead with 2mm Plug
Extremely low internal resistance
Very low operation temperature
Over temperature protection
APEC MoSfets (Taiwain)
Battery Type: 6S~12S
LV Cut off Type (Ignore, Reduce Power, Stop Motor)
LV Cut off setting (2.5~3.5v in 0.1v increments)
Timing (Auto, Very Low, Low, Normal, High, Very Hgh)
Active RPM Control: On/Off (Governor Mode)
Default factory settings.
Battery: LiPo Auto Detect
Low Voltage: 3.2v (power down motor)
Note: Programming box now available, check the related items below.
Kapacita ( mAh )
Hmotnost ( g )
I purchased this speed controller after the one I wanted was out of stock. I am running 12s on a large turnigy aerodrive motor on a Sig Rascal 110 inch. I have not been able to get it to function with 12s. First I thought it was my solder connections, but I redid them all and they are good. I discovered it runs perfectly on one 6s battery. I am programming with the transmitter. Also, some of the description on this page is incorrect. It does not autosense cells and the timing only does automatic, medium and high. I am waiting on the programming box to get here. Maybe I will have better luck with that. If it ends up working on 12s I will amend my review. Right now I cannot use it.as i have got the 55 low vloltage, i needed
a HV esc so i gave it a go.
Well All i can say it IS as good as a Castle
very smooth ran 8 cell on a AXI 4130/16
was over 2000watts very easy no drama, just got on with it
yes i would get another oneUsed the programming box to set-up, running 12s @ 60A full load current, can't fault it prefer it to my Hobbywing 100A HV ESC. Very good value.Horrible. Lit on fire while on a SK3 6374. Burned my model down.Running an APC 16x12 on 8 cells works perfectly. Have had not one issue with this esc for over 2 years now. Would buy again.Eigentlich wrde ich dem Teil keinen eintzigen Stern verleihen. Nur nach zwei Rundflge ist das Teil abgeraucht. Schwach.Does what it is made for. Runs on 10S and motor is smooth, regulation is linear and it seems to reach its specs. So as of now, good product.Works as it should. No issues so far. recomended product.Der Regler arbeitet mit einem SK 6354/245 und 10S perfekt. Gutes Leerlaufverhalten.
Preis/Leistung passt. Wrde ich wieder kaufenI am using this for my mountainboard. Don't buy those for your project if you don't have V-brakes. Braking with this esc will block your wheel. Overall good preformance on 10S with 2.7kW 6364 SK3. Smooth throttle response. I have aprox. 50km on my board and everything seems fine.