Turnigy MG958 Composite Digital Metal Gear Servo 15kg / 65g / 0.2sec
Control system: +pulse width control 1520usec neutral
Required pulse: 3-5V peak to peak square wave
Operating voltage: 4.8V
Operating temperature range: -20~+60C
Operating speed: 0.2sec / 60 degree at no load
Stall torque @ 4.8V: 166 oz/in. (12.0kg.cm)
Stall torque @ 6.0V: 200 oz/in. (15.0kg.cm)
Operating angle: 45 deg. one side pulse travelling 400usec
Direction: Counter clockwise/pulse travelling 1520-1900usec
Motor type: Coreless motor
Potentiometer drive: Indirect drive
Bearing type: Dual ball bearing
Gear type: All metal gears
Connector wire length: 12in
Dimensions: 40.2 x 20.1 x 36.8mm
Weight: 2.24oz. (65g)
Hmotnost ( g )
Unit Weight (g)
Točivý moment ( kg) (min . 0,01 kg )
Rychlost ( Sec / 60deg ):
A ( mm ):
B ( mm )
C ( mm )
D ( mm ):
E ( mm ):
F ( mm )
I have been using this servo now for more than 2 years on my 1/8 onroad car on steering and found it very good the gears are durable because they are metal but first it was little bit noisy but more I used it the noise reduced I can asure that it has coreless motor 15 kg and it is faster than 0.20. I have branded servos that cost over 100 euros each and compared to this servo they have nothing special so I will recomend it.I bought 2 TGY-MG958 for a steering servo on my Losi 8 2.0 Brushless.
After about 4 hours, the first servo has blown and broke my receiver !!!
The second one , after only 2 hours, doesn't brake enaugh ...
I bought 5 of them and I binned two ,they were wobbling in neutral, they are rubbish.
Also Hobby king should get their act together customer help stinksI bought theses servo's, to see if they at least work Reasonably good.. I've put 1 in my Kyosoh UltimaSC, and 2 in my crawler..
So far I'm happy with the performance.. They seem more precise then the stock servo's.. At this price they seem like good value to meReceived my servo and was very happy with the product from the point of view, but with the maiden I lost my 50cc Porter plane cause of poor electronic quality and after I inspect the servo that cause the crash, I've realized that the IC's come lose just because of the gas motor vibration. The servos was installed with crommets and screws that come with the product. NOT HAPPY AT ALL!I love these servos, fast and strong, use five of them in my TZ 50 and it works great! Even with the Solid G mini gyro and KDS flymentor3D.a super servo very strong and good power centres well i am using this as a steering servo in my 1/8 scale buggy and does the job veryplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusplusI have 6 of these for sale brand new, in USA.
They are good servos, as posted by other reviewers on this site.
Purchased these about 3 months ago for my 100cc airplane, but I am now going with 7 volt servos. These servos go 4.8 to 6.0 volts.
I can be contacted at miklleenAThotmailDOTcomI've bought it a year ago, I plug in TT01ED but i use my kit for a rally in my backyard. and eventually died three days ago, hahhaa .. overall this is the best servo performance and best price for a highly capable servo thanks HK