MultiStar ESCs are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If you're starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These V2 ESC's features BLHeli software for a very smooth yet linear throttle response, without sacrificing a rapid, crisp, response to any throttle input.
The nano 6A comes with easy to solder power and motor tabs for a tidy and light install, and comes with 2mm bullet connector and wires for use as well.
All Multistar ESC's feature an ATmega MCU that opens the door to customizable firmware – The V2 Multistar comes with BLheli software pre-installed, and for those so inclined a ease to use USB tool is available for Configuration and updating via the BLHeli Suite GUI.
Please refer to the related items below for a solder free multi-rotor power solution to suit your next multi-rotor project.
• BLHeli Software
• USB tool updating and configuration via BLHeli GUI software
• Smooth and linear throttle control
• Fast response to throttle input
• Atmel MCU
• Stalled motor protection
• Throttle signal lose protection
• Safe power-on (throttle lockout)
• Support 480Hz+ high refresh rates (up to 499hz)
• Supports OneShot125
Constant Current: 6A
Input Voltage: 2-3 cell Lipoly
BEC: Yes (linear) [Remove middle wire to dissable]
BEC Output: 5V/.5A
PWM: 8 KHz
Max RPM: 240,000rpm for 2 Pole Brushless Motor
PCB Size: 21mm x 11mm
Discharge Plugs: Solder pads
Motor Plugs: Solder pads
Kapacita ( mAh )
Hmotnost ( g )
Great little ESC for small builds!! And 500mA LBEC is more than enough for a small receiver and FCB!! Love how it has soldering tabs instead of wires, this allows for it to be hardmounted to some frames without a need for zipties, making for a lighter build!! connects well to the BLHeli Suite via the Multistar USB adapter, and flashes well (I updated to version 12.2, which I found works great on my 10A Multistars). Definitely on my list of things to get more of!!Really small size and little weight.
Personally I would remove the internal bec that is quite unusefull.
Mittels des Programmieradapters problemlos einstellbar und bisher einwandfreie Funktion. Bin soweit sehr zufrieden.Belle ralisation pour faire un mini quadri ou mini tricoptre.