MultiStar ESCs are a quality speed controller at a fantastic price! Designed for simple installation and easy setup these ESCs have proven to offer excellent performance when used in Multi-rotor applications. If you're starting out in Multi-rotors and need an easy to install solution that is tested and proven to work with Multi-rotor craft then these speed controllers have you covered.
These V2 ESC's features BLHeli software for a very smooth yet linear throttle response, without sacrificing a rapid, crisp, response to any throttle input.
The nano 6A comes with easy to solder power and motor tabs for a tidy and light install, and comes with 2mm bullet connector and wires for use as well.
All Multistar ESC's feature an ATmega MCU that opens the door to customizable firmware – The V2 Multistar comes with BLheli software pre-installed, and for those so inclined a ease to use USB tool is available for Configuration and updating via the BLHeli Suite GUI.
Please refer to the related items below for a solder free multi-rotor power solution to suit your next multi-rotor project.
• BLHeli Software
• USB tool updating and configuration via BLHeli GUI software
• Smooth and linear throttle control
• Fast response to throttle input
• Atmel MCU
• Stalled motor protection
• Throttle signal lose protection
• Safe power-on (throttle lockout)
• Support 480Hz+ high refresh rates (up to 499hz)
• Supports Oneshot125
Constant Current: 6A
Input Voltage: 2-3 cell Lipoly
BEC Output: N/A OPTO
PWM: 8 KHz
Max RPM: 240,000rpm for 2 Pole Brushless Motor
PCB Size: 21mm x 11mm
Discharge Plugs: Solder pads
Motor Plugs: Solder pads
Hmotnost ( g )
works great i am using them with 3s Multistar V-Spec 1304-3100KV 3x3x3 prop 5 packs in and it is still running coldI got 3 of these together with one of the LBEC versions for a shall 200 size multirotor. Really easy to flash (I updated to BLHeli 12.2 which works fine for me), fit really well and I love the size and weight for my build. Thanks to the soldering tabs instead of wires, I was able to hardsolder them to the frame PDB and saved weight on zipties even! Run cool, respond well... definitely on my list of good items!!A bit pricey but otherwise perfect for my micro projects.
It is easy to solder the pads. I usually desolder the plus, minus wires, leaving just the signal wire.
I am using exclusively these on my 150-sized diy quadcopters, with 3100kv brushless motors and 4" props.
AUW 111g wihout battery, 157g with 950mAh/2s, flight time 10 minutes with this config.
The fpv models are ~180g AUW, capable of making 720p video and having range of 300m and flight time of 10 minutes.
Soon I will buy more of thses again :-)ESC extremely light (2g is true !). Running with 4x DYS 1306-2300KV BX and mounted on a Turnigy Micro-Quad. Quad weight is only 127g without battery. Get not hot after 5 minutes flight. Satisfied