Now officialy approved by ROAR for race use!
More than just a fancy name. TURNIGY nano-tech lithium polymer batteries are built with an LiCo nano-technology substrate complex greatly improving power transfer making the oxidation/reduction reaction more efficient, this helps electrons pass more freely from anode to cathode with less internal impedance.
In short, less voltage sag and a higher discharge rate than a similar density lithium polymer (non nano-tech) battery.
Unfortunately with other big brands, numbers, ratings and graphs can be fudged. Rest assured, TURNIGY nano-techs are the real deal, delivering unparalleled performance!
Voltage: 1S2P / 1S Cell / 3.7V
Discharge: 50C Constant / 100C Burst
Weight: 148g (including wire & case)
Balance Plug: NIL
Discharge Plug: 4mm Bullet-connector to your own custom plug
Model no: NC5000.1S2P.50
Advantages over traditional Lipoly batteries;
• Power density reaches 7.5 kw/kg.
• Less Voltage sag during high rate discharge, giving more power under load.
• Internal impedance can reach as low as 1.2mO compared to that of 3mO of a standard Lipoly.
• Greater thermal control, pack usually doesn’t exceed 60degC
• Swelling during heavy load doesn’t exceed 5%, compared to 15% of a normal Lipoly.
• Higher capacity during heavy discharge. More than 90% at 100% C rate.
• Fast charge capable, up to 15C on some batteries.
• Longer Cycle Life, almost double that of standard lipoly technology.
The nano-core technology in lithium ion batteries is the application of nanometer conductive additives. The nanometer conductive additives form ultra-strong electron-conducting networks in the electrodes which can increase electronic conductivity. These additives create the ability for imbibition in the carrier liquid to supply more ion channels.
This improves the ability of ion transmission and ion diffusion. Through improving electronic conductivity and ion transmission, the impedance is reduced and the polarization of high rate discharge decreases greatly.
Hmotnost ( g )
Kapacita ( mAh )
Výboj ( c )
Délka -A ( mm):
Výška - B ( mm ):
Unit Weight (g)
Max Charge Rate ( C ):
Great little packs. Quality wires.Perfect for gt-10x pan car. Comes with two strong wires, red and black, without a charger conector, so you have to solder one. No need to have a balance plug because is just one cell battery.Love this battery pack. Good punch to it. Ran for a whole season of oval racing and still running strong. I dislike the "birdcage" bullets since they then to lose grip over time (I prefer the other kind), but so far so good. I do like that the wires are replaceable and ready to accept my own connector type. Good price for a good pack. Highly recommended.This is a very well assembled battery. The fit and finish are tight and clean. The graphics are attractive. The included wire leads are 12Ga with pre-soldered 4mm bullets on one end. I will be using this battery to power the glow driver on my five cylinder radial engine.Just received mine today.. fit and finish were terrific. Great solid case, bullets that I can just wire right in if I want. I am using this in a 1/12 pan car, so I will take the bullets to 16g wire - but the point is.. for the money.. these batteries are great. 14days to Canada btw :)Couldn't you offer a LPo with the 1/12 size in ar hard case with 2s. A lot of hobby drivers hate to drive there Pans with 1s, due to the expensive ESC, Motors...Great Battery. I race it in 1/10 WGT with many A main results. I also run 8 min in 1/12 13.5 and lap times are consistent to the end with very little drop off. I highly recommend and a great price as well.Gr8 battery bought 3 for my zenoah ignition & fuel pump on a full charge I get around 3-4 flight of 8 mins each fuelpump now fill at a super fast rate that I cant handle so I charge it for long storage & it fine now.