Designed to provide reliable and clean power for 3D parkflyers. This brushless outrunner will provide more power and with its high efficiency, long run times.
A quality motor, built specifically for planes designed to fly with a 250 watts brushless outrunner.
Battery: 2~3 Cell /7.4~11.1VRPM: 1020kvMax current: 22ANo load current: 8V/1.1ACurrent capacity: 28A/15secInternal resistance: 0.06 ohm
Weight: 81g (not including connectors)
Diameter of shaft: 4mm
2S~3S Li-Po / 6 ~ 10-cell Ni-MH/Ni-Cd
10x7 ~ 12x6 prop
Suitable for sport and scale airplanes weighing 20 to 30 ounces (565–850g).
Hmotnost ( g )
Kv (rpm / v)
Maximální proudy (A)
Výkon ( W ):
Délka B ( mm ):
Může Délka D ( mm )
Maximální napětí ( V)
Hřídel A ( mm ):
Unit Weight (g):
Průměr C ( mm )
Celková délka E ( mm )
Odpor ( mh):
Great motor for the best priceSolid nice size motor. Have not used it yet but looks niceThis is a Great Motor - you will be happy 3 cell 2200 Lipo 12/6 prop put on an old Typhoon 3D 40" Foam you can not go wrong with these motors
..I have many different Turnigy motors in my planes, for example SK3 XP, Easy Match, etc. This motor is the most smooth and quiet running of all. I fly it with an 11x4,7 Slowfly propeller and it draws 28A Peak on the ground with a prewarmed new Nanotech 1500 3S 45C LiPo. Motor stays cool with 6 Minutes 3D Flying.exlent motor very good for 3d and planes like thatThis is a Great Motor!
Put an APC 11x5.5 on it, match it with a 3s 2200mah 30c Lipo and use the Plush 40 amp speed controller. (You won't be disappointed)Quality motor and good value. I'd buy again.This is best motor for my 3d slick 48 inch....thanks you hobbyking that this item arrived today within 4 weeksdobry motor, maly odber, vydrziGreat motor works really well with Plush 40 esc and a 1300 to 1500mA 20c or better battery. Have used in several planes now. LOTS of power for 3D in 20oz plane weight range like the EPP 3D MX2. Works fine at 24oz 3D plane weight as well.
I use a 10x.3.8 prop for good power and long cool run times.