Introducing the Turnigy SK450 quad copter powered by Multistar. Turnigy set out to make a great value, easy to use, plug and fly quad copter without compromise. The result is a quad copter using all top tier components and proven performance.
Turnigy started with the popular SK450 frame known for its durability, then added some detail changes with Multistar green front arms and a crash dome for the flight controller. For the power system, Turnigy looked to the proven Multistar line of motors and ESCs, choosing the powerful 2213 and matching them with Multistar 20A speed controllers. When it came to the flight controller the choice was clear with the much loved KK2.1, all pre-configured and setup in X mode. The Turnigy SK450 comes with 2 sizes of props; 8 inch for 2200mah or smaller batteries and 10 inch for larger batteries or for those who want to add a camera for capturing a bird’s eye view. Turnigy wraps up the package with a purpose built carrying case with pre-cut foam inserts for the quad copter, transmitter, batteries, and all of the accessories, making transporting and storage a breeze.
Turnigy has done all the hard work for you. Don’t spend hours trying to work out the best components to use or time assembling. Get out there and start flying with the new, plug and fly, Turnigy SK450, powered by Multistar.
• Special edition SK450 frame
• Multistar power system
• KK2.1 flight controller
• Includes transporting box with foam inserts
• 2 sets of props
• Pre-assembled and tuned
Wheelbase or Motor to Motor Diagonal: 450mm
Weight: 680g without battery
Motors: Multistar 2213 935kv
ESC: Multistar 20A
Propellers: 0845~1045 2xCW 2xCCW
Flight Controller: KK2.1
1 x SK450 plug and fly quad copter
4 x 0845 inch propellers 2xCW 2xCCW
4 x 1045 inch propellers 2xCW 2xCCW
Velcro Straps and spare hardware
Integrated box case with foam inserts
1 x 2200mAh 3S 11.1V LiPoly Battery and charger
1 x 5ch radio system
Kapacita ( mAh )
Hmotnost ( g )
very terrible firmware ESCs
there are two possibility, change esc with other type, or remapping this with simonk firmware...
absolutly impossible to fly...
this is the problem during the throttle calibration:
for remapping it's necessary buy the atmel socket cable, and atmega usb adaptor... but there are 3 tipe of usb adaptor (the board of usb adaptor have a different chip and pin position)SK450 is an Excellent Frame, overall the multistar esc are garbage, for a stable fly you need to change these with simonk esc
-motors are OK
- you need to change the multistar esc, buy 4 pair of 20 ampere chinese simonk esc , with 3.5 mm bullet , the quad will change, it will be more and more stable
-kk is not so bad, you need to do setting in the right way
- use only carbon/nylon mix propellers, the gemfan are only nylon and are not good at all is cheap plastic garbage, only buy dji propellers, that are compatible with the motor s shaft
good quadcopter, but dont use 10" props/ On 8" fly good!
this video, how it can fly without fpv
https://youtu.be/lglEBpkGze0Very pleased! My first quadcopter, pretty easy to set up and very well-built. Didn't need to flash or upgrade anything just set up my radio and receiver, then started to practice!Very nice package to get into multicopters if you already have a transmitter/receiver (I only flew airplanes up to this point). The propellers needed a bit of a trim to balance them, but that is needed on all propellers, especially the cheap ones.
I was able to tune it and get it responsive and without any wobble with the smaller propellers (8045), but couldn't get all the wobbliness out with the larger ones with the original ESC firmware.
Note that the stock ESCs give up if you get the throttle too low and the motor stalls and it won't start up again until you disable the throttle for a couple of seconds and start it up again, I crashed because of this, but it survived a 15 meter fall into a dirt field with nothing broken, the frame is very sturdy!
Because they are supported, I reflashed the ESCs with SimonK's firmware and now it's perfect, if one motor stalls it keeps trying to spin it up.
I've made a tutorial on how to flash the firmware on this ESC: https://www.youtube.com/watch?v=_ijB-HAgJ3k
As a final note, I think a high quality transmitter/receiver might be more noticeable on a quad than on a glider, it might be obvious for a veteran, but if you are thinking about upgrading your transmitter, getting into multicopters might be the right time to do it. Right now I'm using a Turnigy i6 and the throttle control could be a bit more precise, but it will still fly just fineI fly my sk450 4s with 3200 mAh and 8x4.5 prop. No problem (flytime:15 -20 min.). I made a wire from the battery to the KK2.1.5 and alarm at 144 volts. To increase the visibility I made four LEDs under each engine ( two blue and two red, connected in my receiver 5V). Nice drone to learn flying and understanding the settings for a drone. It's a good basic to build it out to FPV - the KK2.1 has an option for a selfmade gimbal - see YouTube.
The quality of the ESC's, props and engines could be better.NOT ARF. Its totally uncontrollable and dangerous. I have spent hours watching videos and doing research to try and get this to fly, I have done all the setting recommended and its still not any better. I have heli 450s and planes so am not new to RC. You might be lucky but I would NOT buy this again.Nice, crash proof frame, supplied with 8x4.5 props and 10x4.5 1 set each.
Straight out of the box on big props i had really hard time to keep altitude steady and auto level was a bit unreliable.
with 8x4.5 everything was lot smoother, but at cost of reduced flight times and lifting capability, just managed to take off with extra battery as a load.Used 2 3Ah multistar batteries.
Didn't test lifting with 10x4.5 props as first set got snapped due to mentioned stability issues combined with total noob piloting it.
Flew once then the KK smoked. Changed boards 4 times...every time I connect 11.1v the boards literally smokes. Now I have to try to get a refund, should be fun...not. I will keep you posted on HK's excellent customer service regarding faulty merchandise.Really good value for money!, bought this for 130 euro including shipping, and wow, it's quite unstable out of the box, but balancing props doin sum programming and you got urself a really nice flying quad for a really low ammount of cash, i recommend this to anyone, thanks HK!