Turnigy ultra light Slowflyer is Plug-n-Fly ready. This very light Slowflyer comes with 6A brushless power system, pre-installed servos and 2S lipo. Just plug in your receiver and you will be ready to go.
Upper wingsopan: 415mm (16.3in)Lower wingspan: 385mm (15.2in)Length : 410mm (16.1in)Flying Weight: 58~64gMotor: C05 Brushless outrunnerPropeller: GWS4025 slowflyer propESC: 6AmpServo: 2x2.5gBattery: 7.4V 2S 120mah Lipo
Required:Your own TX & RX
Kapacita ( mAh )
Hmotnost ( g )
THIS BI-PLANE IS POORLY DESIGN. RADIO COMPARTMENT IS TO SMALL, PUSH RODS DO NOT LATCH PROPERLY, WIRING WILL HANG-OUT, AND SERVO NEED TO BE GLUED IN PLACE.This Bi-Plane is poorly design:
-no space for required radio equipment.
-noise lead weight falls out of compartment.
-push rods have weak latching device.
-wiring will hang out the aircraft.
Unfortunately this excelent product is no longer available.
It has been replaced by a s*** newer product.
I had the same problems as the others below.
Unglueds wings and engine and fragile links that had to be replaced.
Flying gracefully ...
My first real solo flight after training on simulators. I took my virginity to him. haha
Now, nobody can stop me!Fastest shipping experience I had was with this plane. Got it in just five days. Build quality is quite poor though as others might have experienced. The motor mount came loose when I first opened the box quite possibly because of handling, the mount scratched some of the surfaces on the top wing. another thing other buyers might experience is the elevator horn being glued on. I had to cut the plastic rod head to make the horn more agile. I haven't flow the plane. Well I kind of tried to. I probably made some noobie mistakes on this plane. So I'm just gonna try and make the nose lighter.
Hobbyking should make this into a kit. Much more easier than having customers complain about the horn and mount. All and all, I still love this plane. Looks awesome for beginners. And Please make parts for this plane too.Easy to fly and flies well, but some parts are too weak. It has a small weight in front. I removed it and used a bigger battery (300mh) instead. You can fly it as far as your eyes can see.ein schnes kleines Indoor-Modell, habe es den ganzen Winter in der Halle geflogen. Die Motorkraft ist ausreichend, das Flugverhalten gut. Richtig entspanntes Fliegen!I bought this plane nearly a year ago, and my feelings are mixed:
this little thingy is loaded within minutes, and always ready to go
after some time its fun to fly
I crashed it _lots_ of times and never had any bigger damage
- this is no "garden flyer" - you need some room to fly this plane, especially if its a little bit windy.
- it's terrible to handle, my first ten flights ended on the ground or in a bush within 10 seconds (well it was my first small model, all my other models are bigger)
- the propeller was missing
all in all this plane is ok. if you don't expect an easy to fly beginners slow flyer (I wanted to teach my gf to fly with this thing, and could hardly handle it myself :D )
apart from the missing propeller the quality is good.Take extreme care unpacking this plane it may have moved free in transit. I recommend cutting the box off the styrofoam packing.
As supplied this plane flew with no trim changes. Will do a short take off or scale take off. Will fly figure 8 pattern using an area less than 30' by 60'. Touch and go, no problem. C of G appears to be correct.
HOBBY KING please mark the packing "THIS WAY UP"motorhalter abgelst
servoarme nicht ausreichende beweglichkeit durch fehlende Aussparung
unklar, wo der CG ist , kann da jemand helfen
does somebody know, where the CG has to be?