Turnigy 620DMG+HS High Torque Digital Servo (Metal Gear)10.6kg / 0.13sec / 52gFeatures:• Double ball bearing (Si-oil)• CE Certified Strong 3 Pole Motor• Heavy duty sealed water proof case• Alloy heatsink• Digital signal design with 100% fitting square PWS• Automatic measures central ms• ALU 6061 alloy and C95 gear material• Digital IC (SOP package with 12bits transfer data)• MOS-FET driver (spirited driver able to push over 7A power)Specs:Weight: 52g / 1.84ozDimensions: 40.5 x 20 x 42mm / 1.60" x 0.78" x 1.62"
Torque At 6.0V: 10.6kg/cm , 147 oz/in
Speed At 6.0V: 0.13 sec / 60° at no loadOperating voltage: 4.8 - 6.0VSpline Count: 25
Hmotnost ( g )
Rychlost ( Sec / 60deg )
Točivý moment ( kg) (min . 0,01 kg )
Unit Weight (g):
A ( mm ):
B ( mm )
C ( mm )
D ( mm ):
E ( mm ):
F ( mm )
Un poco ruidoso con el receptor fly sky th9 tiemblan un poco cuando están en reposo aunque nasa exagerado.???????? ?????, ???????? ?????????? ?? ???? ?????? 4,6Spitzen Servo.
Sehr krftig, sehr wenig Spiel.
Braucht wenig Strom, nicht von den 7A abschrecken lassen...
Bewegt bei mir beide Pendelhhenruder an einem 90mm EDF Jet.I have around 30 of these in various things. I have them in redwing 50cc planes set up for 3D and they perform excellent, even on 3 inch control horns. I also have them in two top flite giant warbirds including the p-51 and the p-47. I don't hesitate to use these on any plane. The current draw on them is lower than expected as well. They are a good choice.good Turnigy 620DMG High Torque - DS/MG 10.6kg / .13sec / 52gBought four of these servos for a 60 inch Decathalon. Worked great for two flights, then three of the four burned up! Eventually the fourth quit working too! These were gentle flights using only 4.8v. There is no reason they should have quit working except poor quality. Besides that, they required a lot of power. Would not recommend!
Excelentes servos, estou usando 5 deles em meu extra 50cc, e em todos os meus aeromodelos, recomendo!!!Very nice these servos tunigy, the worse thing is the arms, is necessary to search some adapted for the planes.Let me put it this way, I have bought over 20 of these things for various giant scale warbird applications as well as for my 50cc 3d birds, the centering is excellent, the holding power is excellent. They sit slightly deeper than a standard though so you may have to plan ahead. I have been using these for 3 years with no failures, and have found little wear, if any, very satisfied. They outperform and outlast my hitec MG servos.