The Walkera QR X350 revolutionized the multi-rotor market upon its release in 2013 by bringing GPS stabilized mutli-rotor flight to the R/C market at an affordable price. Walkera is breaking the rules again in 2014 with the release of the all new QR X350 PRO, which boasts a whole host of new features and optimization for aerial video/FPV use.
The all new Walkera QR X350 PRO provides astonishing 25 minute flight times on the stock power system, features the all new DEVO-M flight controller providing improved stability/GPS position holding and also is "Plug and Play" compatible with Walkera's G-2D brushless camera gimbal.
The QR X350 PRO has an enhanced altitude sensor which adopts GPS technology allowing it to work out its exact position in reference to the world, this allows the QR X350 PRO to hover in a stabilized position hold mode. With a simple one switch flip or loss of signal the QR X350 PRO will fly itself back to its take-off position and land! Additionally, it offers a manual mode for the sport flyer and even an onboard low voltage warning system to alert you when it’s time to land.
This version of the QR X350 PRO is in "Plug and Fly" form, meaning that you will simply need to add your own radio system (transmitter & receiver) and 3S Lipoly battery. The QR X350 PRO is also plug and play compatible with the G-2D brushless gimbal (sold separately).
• Plug and Fly - Simply add your own radio system and battery
• Capable of 25 minute flight times with Walkera 3S 5200mAh Lipoly battery (sold separately)
• Improved precision flight control system
• Enhanced GPS position holding
• Altitude sensor
• Compass sensor
• G-2D brushless camera gimbal ready (sold separately)
• One Key "Return to Home"
• Stable Mode with GPS and altitude hold
• Failsafe to return home & landing
• Low voltage protection
• Balance charger with world compatible wall adapter
• Easy to see LEDs
Main rotor diameter: 556mm
Main rotor blade length: 206mm
Brushless motor: WK-WS-28-008A
Brushless ESC: WST-15A(G/R)
Main Controller: DEVO-M
Battery: 3S 11.1V 5200mAh Lipoly (sold separately)
Flight time: 25 minutes
Brushless Gimbal support: G-2D (compatible with iLook and GoPro Hero 3) (sold separately)
Walkera QR X350 PRO Plug and Fly Quadcopter
Minimum 6CH transmitter and receiver (8CH or more for full brushless gimbal tilt/roll control)
3S 11.V 5200mAh Lipoly battery
*Note: The QR X350 PRO uses 3.5mm bullet connectors for the battery plug. An XT60 adapter is available, please see related items below.
Kapacita ( mAh )
Hmotnost ( g )
this is my first quadrocopter hope it does not disappoint mefor the price , quality is very good. i using with Orange/Futaba 8 ch receiver (without case), internal space is very tight.
motors are ok, but could be better. i will change when i put the gimbal and camera.
here a short video of my QR x350 pro, flying on loiter and manual mode:
Shipping took just over one week to receive the x350 Pro in the USA. I installed a Futaba R617FS receiver and use a Futaba 7C transmitter for control. Only one of the 5 cables that are required to connect the R617FS receiver to the Devo-M flight controller were included. I had to make the other four cables. I setup manual, position hold, and return to home flight modes, operated by a three position switch on the transmitter. The flight modes all work great. I have not implemented the IOC function at this time. I've also installed key chain camera to record flight videos. I have limited experience with quadcopters, but I feel the X350 Pro is very stable and great fun to fly.Just an Update to let you know the Walkera QRx350 Pro can be programmed by Mission Planner just like the APM 2.6, You can Use all 6 flight modes on the QRX 350Pro as on the APM, and adjust the voltage for the QRX350 Pro to return to launch and Not just LAND, Thanks to the guys at RCgroup. c o m,Iv had the QRX350 PRO about a week, Shipping to UK,3 weeks,Done the LV mod and getting 8mins from a 2200Mha 3 cell, Will be using test the 5200Mha over the next wekk,Im using a Frsky Taranis with the X8R Installed in quad, Used RCGroups to sort the config out, So far GPS is very quick to get signal, Holds well in the right mode, Not tested the RTL function YET as I have only flown within my boundaries ,