The Runner 250 is the latest offering from Walkera which is packed with innovative features specifically designed for the FPV Racing fraternity. The modular design of the runner 250 allows you to change out race damaged components in a matter of minutes.
The speed controllers, flight controller, FPV transmitter, receiver, OSD and LED Lights are designed to literally plug straight into the integrated printed distribution board meaning no soldering is required making the Runner 250 super easy to build and repair between races.
The full carbon fiber main frame of the runner 250 is super compact and tough and can easily handle those inevitable high speed gate collisions while the built in forward and rear LED lights help you with orientation when flying the runner 250 in line of sight.
This PNF (Walkera DEVO compatible)* version of the Runner 250 comes supplied complete with 2100Kv motors with matched ESC's, Runner 250 flight control system and self tightening toughened composite props making the Runner 250 the perfect solution for beginners and pro FPV racers alike.
• PNF (Walkera DEVO compatible)* 250 size racer
• Fully factory assembled
• Modular design for easy build and repair
• Self tightening toughened composite props
• Compact carbon fiber main frame
• Dampened camera mount platform
• Front and rear LED lights
• 12-14 mins flight time
Frame Diameter: 250mm
Weight: 530g (with battery)
Flight Controller: FCS-Runner 250
Brushless Motor: WK-WS-28-014 (CW/CCW)
Brushless ESC: Runner 250
Battery: 11.1V 2200mAh 25C 3S LiPo (not included)
Flight Time: 12~14mins
Working Temperature: -10?~ +40?
1 x PNF/B&F* Runner 250 Quadcopter
*Note: This version of the Walkera Runner 250 includes a pre-installed DEVO-RX710 receiver. This receiver can be easily disconnected/removed allowing you to install a receiver of your choice (via the receiver plug connections on bottom of model), allowing you to use the radio system of your choice.
Hmotnost ( g )
Destroyed 4 M2 hex keys trying to screw Runners plastic legs! All screws go inside up to the middle and the hex key start to slip.Nice Clean,well built frame with strong design and rigid frame, putting it together was fairly simple difficulty was with the Hex Screws 2 x 14 and 2 x 7 HEX head bolts, they are really tight to put in the SKID and the Frame they will bust the hex key and will do so right were you cant grab it with a pair of pliers be warned.
I had to replace mine with regular phillips head screws which made the build much easier.
Great looking bird, rugged and sleek, the kit was great and all supplied was a great fit, great job from walkera very minimal wiring which makes the build look super cool.
took roughly 3-4 hours with the HEX screw issues, but very easy and fun build.
The second warning is with the servo input output plug there is only 1 5v plug for the RX the others are single signal wires only "not the regular 3 ,black red and white plug" servo extensions they are single signal wires only , you can use a extension in series for just single wire bridges. meaning run the plugs horizontal not vertical.
this will make the build time easier , i also used 1 single wire to complete the GEAR "walkera" FLAPS "Futaba" channel