The X-CAM A10-3H Gimbal it at the top of the list when it comes to gimbals, the A10 has True continuous rotation 3-Axis ability with A/V Video link transfer. Full control over Roll, Tilt, Yaw, Mode and Zero home. And charging with A/V out transfer for the GoPro hero camera.
There are a lot of 3 Axis gimbals on the market, but only a few that use a slipper for true 360Deg continues rotation and also transfers the A/V output from the GoPro to the top controller for VTX use. The A/V line also powers/charges the GoPro. Another key feature on the X-CAM is its ability to go to zero or home using referencing sensors, this is great for when transitioning from a yaw control to a forward flight mode the gimbal will auto go to the front position.
The A10 uses an advanced method of vibration control and mounting and is a full CNC aluminum frame design with integrated motors for a light 280g weight.
If you’re serious about some aerial Photography with a GoPro this is the gimbal for you
• Continuous 360deg rotation
• A/V transfer cable with power
• 5 chs of adjustment over Sbus
• Sbus and PPM support
• Home sensors
• GUI and Upgrade ability
• Wide input voltage range
• Aluminum construction
Weight: 280g ( without GOPRO )
Stabilization frequency: 5200Hz
Input voltage: 7.4v ~ 16.8v ( 2S ~ 4S Lipo )
Tilt travel: +-90 degree; Roll travel: +-45 degree
YAW travel: 360 degrees unlimited rotation
Hmotnost ( g )
Its very well built and fairly stable
Unfortunately the manual is in chinglish, it only pans in one direction until it hits the zero, the software is SO basic it bugs out on windows and doesn't connect if you run an anti-virus, the controller overheats like anything
DOES NOT respond well to input via pwm and refuses to do anything over cbus
Contacted the people who make it, the "help" they give might aswell be generic phrases that do so little they might as well be reading a take away menu
My advice, don't botherIf you buy this Gimbal bear in mind the following things:
1) The software is very basic and old fashioned
2) The user manual is VERY BASIC and google translated
3) Its really difficult to actually configure it via PPM
4) It's only compatible with SBus1 Systems! Any Sbus2 System (eg Futaba) will NOT work with this gimbal
5) Altough service customer emails are replied, they usually only reply with short generic phrases that don't really help solving the problem you might have.
I WOULD NOT recommend this gimbal.Hallo,
Ich habe heute, im starken Wind, das Gimbel mit GOPRO Hero 4 Silver unter meinem Align M690 ausprobiert.
Das Gimbel ist erstaunlich gut und hlt die Kamera.Im Heading hold Modus kann der Copter Piruetten drehen mit Vollspeed ohne das die Kamera ihren Platz verlt.Betrieben wird der Copter mit der Jeti DC 16 ;2 Empfnger mit der D/S Bus Firmware. Der Gimbel Empfnger im Clone Modus mit umgesetzten Kanlen 12 bis 16 auf 1 bis 5.
I'm really impressed so far! I've only been trying the gimbal on ground, but it preforms excellent!! Motor seems to be pretty small but they work very well. I'm owning the tarot 2d gimbal and I would say it preforms as good as the 2d but with an extra axis. Thanks!!dampening balls are way too soft, i get jello even when stationary on the ground without props spinning. harden them up and they're great. note that the av link output is a 3.5mm jack and i can't seem to get the gimbal to point face down no matter what i do (no option in software)