The JAE series was designed and developed as a result of a joint venture between IMPBA Hall of Fame members Rod Geraghty, David Hall, Ron Zaker and Martin Truex Jnr. The main difference between this hull and the others on the market is the use of sharp edges on the bottom of the sponsons and tub, as opposed to curved surfaces. This helps break the surface tension of the water and makes for a faster boat.
The Mini Sprint is a quick build kit and features a level of pre-fabrication never seen before in a boat kit. All of the hard work has been done for you, it requires only simple assembly and finishing.
A full running hardware kit is included with the kit, machined rudder unit and motor mount, flexi shaft, turn fin, nuts and bolts, propeller and much much more. Also included is a comprehensive step by step assembly manual with lots of photographic images.
You will need the following basic tools and supplies to construct the Mini Sprint:
• Modelling knife
• Spring clamps, G clamps
• 1/16" and 3/32" drill bits
• Flat file
• Round file (3/16")
• Sanding block with 80 and 150 grit paper
• Masking tape
• Primer and paint
• Wood filler
• Epoxy finishing resin
• 30min epoxy
• Medium CA with accelerator
Height: 50mm (excluding rudder and fin)
Addional parts required to complete the Mini Sprint:
450 size brushless motor
50amp electronic speed controller for brushless motors
2 channel transmitter and receiver
Mini MG rudder servo
2S 2200mah lipoly battery
Hmotnost ( g )