2804-210Kv Brushless Gimbal Motor (Ideal für die GoPro auf Compact-Art-Kameras)

• Overall
• Quality
• Value

Customer Rated

Nov 25, 2015

Good motor, I use it for roll in a 3 axis gimbal, I enlarged the threads to 3mm though. very simple to do, just disassemble the rotor and insert a 3 mm tap, work slowly, add a bit of oil. No predrilling required. Assemble it back. Bought two, one had a minute play if you pulled on the rotor casing, just put it on a board of soft wood rotor down and slightly tap it with a small hammer on the shaft (circlip end, do not remove the circlip) checking for play. Adjust the hammer power by slightly increasing it if there's still play. Don't over do it!

• Overall
• Quality
• Value

Customer Rated

Aug 01, 2015

I used these for a decently heavy 3D printed gimbal of my own design. The camera housing weighed 325 grams and these motors worked fine, but was nearing the threshold of over-drawing the 500 mA max that the Tarot gimbal control gives. I tried to use these motors on a 425 gram camera and they would not stabilize the gimbal within the 500 mA allowance of the gimbal controller.

If you decide to design your own gimbal, these will work great on cameras in the 100-300 gram threshold. Remember that gimbal design is mostly about balance than it is about torque. Also, the more jostling your quadcopter or craft does, the more torque you have to put out. So, test your stuff on the ground liberally before flying it!

• Overall
• Quality
• Value

Customer Rated

Nov 20, 2013

these motors should have high quality bearings with no clear ens to the axles images are shaky and a lot of wobble, my next motors will be of a higher quality

• Overall
• Quality
• Value

Certified Buyer Rated

Nov 13, 2013

meka kama nahe podi e ne neda

• Overall
• Quality
• Value

Customer Rated

Nov 08, 2013

I bought 6 units of this motor and only 2 of them work. The windings are open on the rest. Hobbyking needs to improve quality checks ASAP ! I also bought 3 controller boards and 1 unit came with a DIODE bad. Had to replace it myself.

• Overall
• Quality
• Value

Customer Rated

Sep 25, 2013

Perfect motor for GoPro H3 (Roll-axis). Buy the smaller motor for pitch.
Smooth and silent. Very happy with mine.

• Overall
• Quality
• Value

Customer Rated

Aug 29, 2013

enfin ces moteurs chez HK , la on va pouvoir ralis ces propres nacelles a moindre cot comme d'habitude chez HK.
merci