BA BL290S 1200KV Brushless Outrunner 45g

• Overall
• Quality
• Value

Certified Buyer Rated

May 19, 2012

a little grindy.pooor craftsmanship.

• Overall
• Quality
• Value

Customer Rated

Aug 09, 2011

Got just faulty, the wires inside the motor is defective.
The wires are not fixed. When installing all the same break would be.
True motor is not rusty ... and it pleases me very much, I'll throw in the garbage is not rusty motor ... $ 20 : (
I want to put 0 stars.

• Overall
• Quality
• Value

Certified Buyer Rated

Jul 04, 2011

The motor came damaged, more grinding than rotating.

• Overall
• Quality
• Value

Customer Rated

Nov 27, 2010

I have bought this expensive out runner but can't fly due to motor shaft Loose. Im tried to fix it, but the track for setscrew damage. I think expensive is good. But actually expensive is bad.

• Overall
• Quality
• Value

Customer Rated

Aug 18, 2009

excellent motor goes well on my glider with 3 cell 2600 Mah Lipo well worth getting and packed very well good one hc

• Overall
• Quality
• Value

Customer Rated

May 21, 2009

Este motor, proporciona un rendimiento aceptable, pero tiene un problema: el soporte o bancada.

Al ser de aluminio de dudosa calidad,y de poco espesor , se pasa de rosca con mucha facilidad con lo que resulta inutilizado para la mayoria. Adems, su dimetro no se ajusta facilmente, a otro soporte.

No lo recomiendo.

• Overall
• Quality
• Value

Customer Rated

Feb 15, 2009

Good motor have had no problems with it.

• Overall
• Quality
• Value

Customer Rated

Jan 16, 2009

Bought one. When unpacked unit was rusted so much that I couldn't rotate the shaft. pulle dit all apart and cleaned it/wd40 etc etc blah blah - conatcted support but as usual by th etime you send it back and they stuff you around its not worth the hassle or drama. So once again HC stuff is not cheap in the long run

• Overall
• Quality
• Value

Mr

Nov 25, 2008

What a con!

Motor rotor (can) was actually rusted to the stator - rusted as in "I couldn't rotate it by hand". There were no grub screws fastening the rotor to the shaft and only one of the grub screw holes was actually threaded.

An expensive outrunner by the time you tap the other grub screw hole clean the rust off, chase around town to find grub screws that fit etc etc

NEVER AGAIN!

• Overall
• Quality
• Value

Customer Rated

Nov 04, 2008

used this motor for 2 years (approx. 50 flight)in a twin 3.5 lb.on 3 lipo

or 3 a123 and 4 a123

7x6 prop at 12 amp(each)about 30 ounce thrust

nice smooth running bearings.Motor no good for prop over 9"