Hobbyking 3D-Drucker Filament 1.75mm PLA 1KG Spool (Farbwechsel - Grün zu Gelb)

• Overall
• Quality
• Value

unconsistent results

Feb 02, 2019

With the Hobbyking PLA, in 95% of the times I get a clog somewhere during the print resulting in an incomplete print.
I've tried the whole temp range from 190° up to 245°C (I know this is a bit too hot for PLA) but this didn't solve the issue.
In order to verify against other suppliers I've done several prints with other PLa material and these prints were completed with overall good results.
I'm not sure if the HK brand is just (too) low quality of if it has some inadequate roundness,...
Prints have been performed on my Maylan M200,

• Overall
• Quality
• Value

prints well

Sep 14, 2018

printed at 215 initial layer then 210 i found once a few layers had been completed part of the print lifted, was not a reason on the print i was doing to stop the print and the rest was completed without issue and carried decent detail with no stringing or layer issues, the yellow it changes too is more a light green/yellow not full yellow but i can live with that, art the price its worth a try

• Overall
• Quality
• Value

All good at 220°C / 60°C With CR-10S

May 18, 2018

A good value for the price, printed @ 220° C nozzle and 60°C bed, it works.
I have'nt tried yet at lower temp (210).

• Overall
• Quality
• Value

Great Filament!

Jan 15, 2018

I only used the filament for one test print (benchy) so far, and i already like it.
The benchy was printed on my Anet A6 using a temperature of 222°C without heated bed.
I have attached pictures of the result - i will buy this, or some other colors again!

• Overall
• Quality
• Value

Good value, nice color changing effect

Feb 21, 2017

Prints easily and with good results. Good value.