CNC-Aluminium Outboard Stil Boot-Laufwerk w / o Motor (Anzug Hobbyking H2O Stil 650EP)

• Overall
• Quality
• Value

Replacement Part

Jul 31, 2017

Superb faux outboard. Well engineered and assembled all ready for a motor to be fitted. Comes complete with all fittings, clear and concise instructions, tube of grease and allen driver for coupler. Well pleased, thank you Hobbyking yet again

• Overall
• Quality
• Value

Customer Rated

Nov 09, 2014

This motor is 6 inches tall overall
It is 4.25 from the transom bracket to the tip of the prop shaft
"Critical measurement" 2.25 inches from top of transom bracket to center of prop shaft
These outboards must surface run props or things get hot!!
I have three of these that have been converted to 2848 -3900 kv turnigy with hobbyking 70 amp esc's and 3s lipo 5800 mlh 60 c . I have two of these on one boat witch is 25 inches long deep vee, weight 4 lbs rtr and one on a 26 inch tunnel weight 3 lbs rtr , go like a bastard 35- 55 mph depending on rigging technique . Been running CNC 35mm dia props ,1.7 pitch 3 blades on both boats. these outboards not only look great but perform as well . Thank you Hobbyking, make some bigger for 40 and fifty inch boats