Faltpropeller W / Hub 18mm / 2mm Welle 5.1x3.1 (2 Stück)

• Overall
• Quality
• Value

Good and cheap

Jun 02, 2021

I tested them and they have same thrust as 6030 gemfan with prop saver.
I use them on 48cm chuck glider (140g) with 1306 3100kv motor 2s and it goes vertical.
Also had a few hard landings on grass and haven`t broken it. It weights 4.6g with all the screws. I drilled the shaft to 3mm and it spins without any vibrations.

• Overall
• Quality
• Value

Good quality props

May 19, 2021

Great price, prompt service and quality product

• Overall
• Quality
• Value

first look review

Jun 21, 2017

the propellor will fold, leaving around 20mm for the motor diameter.
i ordered a 25mm motor :(

• Overall
• Quality
• Value

Certified Buyer Rated

May 09, 2013

Plastic Folding Propeller Assembly 5.1x3.1 (2pc/bag)good~

• Overall
• Quality
• Value

Certified Buyer Rated

May 03, 2013

Bought these as a replacement for a broken Mini Swift prop.

• Overall
• Quality
• Value

Certified Buyer Rated

Sep 05, 2012

DON'T buy the replacement folding prop for the Mini Swift. These are the same thing, and you get twice the gear for the same price.

• Overall
• Quality
• Value

Certified Buyer Rated

Jun 30, 2012

Exelent petite helice utilise sur un racer stinger

• Overall
• Quality
• Value

Customer Rated

Jun 02, 2012

As expected these are cheap copies of the small Graupner folding props, I'm not complaining though because of the huge price difference ;-)
My only issue is that the spinners are made of a very thin plastic: out of the six units I received, two spinners were bent out of shape in such a way they are unusable.
@HobbyKing: use a slightly bit thicker plastic on those spinners and you have a winning product for your 5-8-10 grams brushless motors!

• Overall
• Quality
• Value

Certified Buyer Rated

May 01, 2012

Custo e benefcio...

• Overall
• Quality
• Value

Certified Buyer Rated

Apr 30, 2012

Nice Little Motor that will power my Nuri XXS. With a tiny screwdriver and a (light) hammer its easy to convert it to a pusher! If you want to do so also, have a look at the pins which hold the blades: one hoel is a bit thinner than the opposite. This one is the side where you have to push out the pin for conversion. Spinner runs not too precise - I expect some vibrations Thats why only 4 stars.