HKPilot Mega 10s Power Module mit XT60 Stecker

• Overall
• Quality
• Value

Seems To Work Fine

Apr 21, 2019

I bought this while building another Tarot 650 Ironman - the previous one crashed during its 2nd test flight when the controller suffered a brownout. I was using 6S power with an APM module that was rated for 6S. This time around I decided to try this one, but I'm waiting delivery of a 6S lipo so I won't know for sure until I test under a full 6S charge, but so far it seems to work using a 4S lipo.

• Overall
• Quality
• Value

Customer Rated

Jun 30, 2016

The connector going to the Pixhawk is the wrong connector (minor pin differences that prevent the connector from going into the board; the side rails and back tabs). There might be a way to shave it down, I tried, but finally pulled the connector off of an old 3DR Power Module and replaced the one on this Power Module. The wire crimped ends are the same for both so it only took a few minutes.

I haven't tried it yet at 9S, but assume that it works if I don't update this post.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 15, 2016

I purchaed 2 for my 2 quads and they are well built. Measures voltage and current accurately on HKpilot Mini.

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 08, 2015

Very well constructed. Only niggle is the thinner wires as they seem fragile. I used heat shrink to stiffen the lead up covering partially the little connectors as well. Powered my HKpilot Mega with no issues! Remember to remove the jumper on the FC if using this! Doesn't heat up and seems efficient! Worth it's purchase!

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 04, 2015

better quality than previous stuff from hk. all soldered well

• Overall
• Quality
• Value

Certified Buyer Rated

Mar 02, 2015

Works, but the connector comes loose easily

• Overall
• Quality
• Value

Certified Buyer Rated

Feb 21, 2015

very good, work well, very easy to use, you are worth a try. the price is very affordable. i use to my APM . thanks